JVC HR-VP470U manual Timer again, Re-perform the VCR Plus+ setup Doesn’t work properly

								E	N	45
TIMER RECORDING
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Timer recording won’t work.		The clock and/or the timer have		Set the clock and/or timer correctly.
			been set incorrectly.
			The timer is not engaged.		Press TIMER and check to make sure
					that ä appears on the front display
					panel.
			The VCR has not been set up properly.		Re-perform the set-up procedures.
					Make sure you have compensated for
					Guide Channel and VCR or cable
					box channel number mismatches
					(	pg. 30).
2.	Timer programming won’t work.		Timer recording is in progress.		Timer programming can’t be performed
					when timer recording is in progress.
					Wait until it finishes.
3.	ä and ] on the front display		The timer is engaged but there’s no		Load a cassette with the record safety
	panel won’t stop blinking.		cassette loaded.		tab intact, or with the hole covered
					with adhesive tape.
4.	The cassette is automatically		The loaded cassette has had its		Remove the cassette and cover its
	ejected, and ä and ] on the		record safety tab removed.		hole with adhesive tape, or replace it
	front display panel won’t stop				with a cassette on which the safety
	blinking.				tab is intact.
5.	ä blinks for 10 seconds and the		TIMER has been pressed when there		Check the programmed data and re-
	timer mode is disengaged.		are no programs in memory, or the		program as necessary, then press
			timer record program information		TIMER again.
			has not been programmed correctly.
6.	The cassette is automatically		The end of tape was reached during		The program may not have been
	ejected, the power shuts off and ä		timer recording.		recorded in its entirety. Next time
	and ]won’t stop blinking.				make sure you have enough time on
					the tape to record the entire program.
7.	We moved, and now VCR Plus+		The receivable stations in the new area		Re-perform the VCR Plus+ setup
	doesn’t work properly.		are received on different channels than		procedure (		pg. 30).
			those in the previous area.
8.	“PROGRAM FULL” is displayed on		All 8 programs of the VCR’s timer		Wait until a space in memory clears,
	the screen.		memory are used.		or cancel unnecessary program
					information (		pg. 34).
OTHER PROBLEMS
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	When scanning channels, some of		Those channels have been preset to		If you need the skipped channels,
	them are skipped over.		be skipped.		restore them (		pg. 15).
2.	The channel can’t be changed.		Recording is in progress.		Press PAUSE to pause the recording,
					change channels, then press PLAY to
					resume recording.
3. The remote control won’t operate			The remote control brand setting is		Re-set the remote control to the
	my TV or cable box or DBS receiver.		incorrect.		correct brand (		pg. 40 or 41 or 42).
4.	Even though Auto or Semi-Auto		The clock setting data received from		Select a different Host Channel during
	clock setting has been selected, the		the Host Channel is incorrect.		the Semi-Auto setting procedure
	clock is incorrect.				(	pg. 12), or perform the Manual
					setting procedure ( pg. 13).

ATTENTION:

This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to malfunction. If the VCR does not operate correctly switch its power off and unplug the power cord from the AC supply. Wait for a while and then plug the power back in. Eject and check the condition of the cassette. If everything appears normal resume operating the VCR as usual.