JVC HR-J259EE After Scan Completed Is displayed on the screen, For about 5 seconds, Seconds each

1 2 3

2

4 5 6

7 8 9

0 4

1

OK

MENU

PUSH JOG

EN33

	VIEW CHANNEL LIST
4	SCREEN
	After "SCAN COMPLETED"	PR	CH	ID	PR	CH	ID
	is displayed on the screen	01	25	– – – –	07	C33	– – – –
	for about 5 seconds, the	02	C08	– – – –	08	C26	– – – –
		03	10	– – – –	09	55 – – – –
	Channel List screen	04	C65	– – – –	10	C24	– – – –
	looking like the one to the	05	C31	– – – –	11	C23	– – – –
		06	C32	– – – –	12	C25	– – – –
	right appears. The stations
		[5°]
	your recorder located
		=		: EDIT
	appear on the Channel List
		= [X] : DELETE
	screen — channel	[MENU] : EXIT
	positions (PR) and			C: Cable
	channels (CH).
	The blueback screen and the program currently being
	broadcast by the blinking station appear alternately for
	8 seconds each.
	To view the next page, use the PUSH JOG %Þbutton
	on the remote control.

	RETURN TO NORMAL
5	SCREEN
	Press MENU.
	● Using the Channel List screen, you can skip or add
	channel positions, enter station names and perform
	other operations. Refer to pages 34 – 37 for the
	procedures.

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you want to perform it manually, refer to page 35.

●If you perform Auto Channel Set when the aerial cable is not connected properly, "SCAN COMPLETED -NO SIGNAL-" appears on the screen in step 4. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.

IMPORTANT

●If no sound accompanies the picture on some channels that have been stored by Auto Channel Set, the TV system setting for those channels may be incorrect. Select the appropriate TV system for those channels. ☞ "TV System Selection – When you see the picture but hear no audio" on page 37.

●Since your video recorder memorizes all detected stations even if the reception condition is poor, some of those stored stations may produce a noisy picture. To delete those stations, ☞ "Delete A Channel" on page 35.