JVC HR-J548E, HR-J748EH Enter Showview, Confirm Channel Position Number, Close Menu

	ENTER SHOWVIEW
4	NUMBER
	Press OK, and a cursor	GUIDE PROG SET
	appears above “GUIDE
		1 2 3 4 5

EN11

When Using A Satellite

Tuner

Satellite Antenna Aerial or Cable

		PROG”. Then, using the
		NUMBER keys, input the	GUIDE PROG	TV PROG
		SHOWVIEW number (found	1	1
		in most TV listings) of a
		program scheduled to be
		broadcast on each station
			[0-9] =
		on the list from step 1,	[MENU] : EXIT
	starting at the top. If you		When entering a SHOWVIEW
	enter the wrong number,
			number for ZDF
	press CANCEL to backspace
	and input the correct number.
		CONFIRM CHANNEL
		POSITION NUMBER
4		Press OK and the display	GUIDE PROG SET
		under “TV PROG” begins
5 blinking.

Ex. 1

Satellite

Tuner

AV2 IN/

DECODER

Ex. 2

Satellite

Tuner and

Decoder

Back of

HR-J748E/EH

If the blinking number	GUIDE PROG		TV PROG
under “TV PROG” agrees
		2	2
with the channel
position . . .
. . . press OK.	[5°] =
If the numbers do not	[MENU] : EXIT
agree . . .
. . . input the channel position using PUSH JOG%Þ or
the NUMBER keys, then press OK.

●If you input the SHOWVIEW number of a program that has already aired, “ERROR” appears on screen for a few seconds. Input the correct SHOWVIEW number.

●Repeat steps 4 and 5 as necessary.

CLOSE MENU

6 Press MENU and selection is complete.

If you already know the Guide Program number for a station . . .

1– After step 3, press PUSH JOG %.

●The GUIDE PROG number begins blinking.

2– Enter the Guide Program number using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG %.

●The TV PROG number begins blinking.

3– Enter the channel position using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG% .

●Repeat 2 and 3 as necessary. 4– Press MENU.

TV Receiver

Back of

HR-J548E

Preparation

1– Connect the satellite tuner to the AV2 IN/DECODER connector on the rear of your recorder.

2– Set "AV2 SELECT" to "AV2" (☞ pg. 32).

To Record Satellite Broadcasts . . .

1– Select the appropriate channel on the satellite tuner.

2– Press NUMBER key "0" to set your recorder's input mode to "AUX2".

3– Start recording (☞ pg. 19, steps 3 – 6).

To Record Satellite Broadcasts Using SHOWVIEW Timer Recording . . .

1– Perform Guide Program Number setting.

●In step 5 in the left column, press NUMBER key "0" to set "TV PROG" to "AUX2".

2– Perform SHOWVIEW Timer Recording (☞ pg. 26).

To Record Satellite Broadcasts Using Regular Timer Recording . . .

1– In step 6 on page 29, press TV PROG. +/– to set the channel position to "AUX2".

NOTE:

When timer-recording a satellite programme, first set the satellite tuner to the appropriate channel before the selected programme begins and then set the satellite tuner's timer. If your satellite tuner does not have a timer, leave it switched on.