Scene Finder
This function helps you check contents of unlabeled recorded tapes at the touch of a single button.
SearchSearchSearch
FF | REW FF | REW FF | REW |
5 seconds | 10 minutes 5 seconds | 10 minutes | 5 seconds |
| on counter | on counter |
|
NOTE:
Scene Finder cannot be used when the recorder is in the Record mode.
ACTIVATE SCENE FINDER
1 Press SCENE FINDER. The recorder starts forward search for 5 seconds and then
●To start Scene Finder in the reverse direction, press SCENE FINDER and then turn the SHUTTLE ring to the left (or press the REW button) within 2 seconds.
This cycle is repeated until the beginning of the tape.
●During Scene Finder, the following indications appear on the display panel:
STOP SCENE FINDER
2 Press STOP.
NOTES:
●During Scene Finder search, you can also hear the tape sound. During fast forward or rewind, you hear the current TV sound instead.
●Scene Finder does not function during Index Search.
Next Function Memory
You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press within 2 seconds.
NOTE:
If you want the power to be turned off automatically when the counter reads “0:00:00” (instead of at the beginning of the tape), press C.MEMORY so that the “M” mark appears before pressing REW.
EN17
Remote A/B Code Switching
The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.
1 |
| REMOVE POWER SUPPLY | |||
| Unplug the mains power cord from the mains outlet. | ||||
2 |
| SET A/B CODE SWITCH | |||
| Set to B. | ||||
3 |
|
| |||
| Plug the mains power cord back into the mains outlet. | ||||
4 |
| TURN THE RECORDER ON | |||
| Press |
|
| on the remote control. The recorder will now | |
|
| ||||
| only respond to B code signals. |
NOTE:
Some TV sets may malfunction in response to the B mode. If this happens, switch back to the A mode.
Counter Memory
Returns to the counter reading of “0:00:00” to conveniently find a specific place on the tape automatically.
1 | SET COUNTER MEMORY |
Press C. (COUNTER) RESET during playback at a point | |
you wish to locate later. The counter reads “0:00:00”. | |
Then press C.MEMORY, and “M” appears in front of the | |
| counter digits. |
| ACTIVATE COUNTER | |
2 | MEMORY | |
When you wish to return to the designated point, press | ||
STOP and then REW or FF. | ||
● The tape rewinds or | ||
| ||
| 0:00:00 automatically. | |
| ● To cancel Counter Memory, press C.MEMORY again. |