JVC HR-J748E Select Language, Perform Auto SET UP, If you are referring to, On-screen display

3 OK

1

PUSH JOG

Language Code
ENGLISH	: 01	NEDERLANDS : 06
DEUTSCH	: 02	SVENSKA	: 07
FRANCAIS	: 03	NORSK	: 08
ITALIANO	: 04	SUOMI	: 09
CASTELLANO : 05		DANSK	: 10

Auto Set Up results appear on the front display panel

● When both auto channel set and auto clock set have been completed success- fully the correct current time will be displayed.

● When auto channel set has

been completed success- fully but auto clock set has not, "CH" will be displayed.

● When neither auto channel set nor auto clock set has been completed successfully, "--:--" will be displayed.

●If Auto Set Up is completed, go to page 6.

					EN	5
3	SELECT LANGUAGE
	Press OK. the Language Set display appears on the front
	display panel and/or on the screen.
	If you are referring to the front display panel
	Press PUSH JOG to select your language code
	%Þ
	referring to the chart in the left column.
	(Ex.) DEUTSCH is selected for SUISSE
		International telephone		Language code
		country code
	If you are referring to		DANSK
	the on-screen display
			SUOMI
	Press PUSH JOG%Þ to		NORSK
			SVENSKA
	move the highlight bar		NEDERLANDS
	(pointer) to the language of		CASTELLANO
			ITALIANO
	your choice.		FRANCAIS
			DEUTSCH
			ENGLISH
			[5°] =
			[MENU] : ENDE
			(Ex.) DEUTSCH is selected
4	PERFORM AUTO SET UP
	Press OK.
		"Auto" appears on the display panel and blinks; do
		NOT press any button on the recorder or remote
		control until the display panel shows the current
		time or "CH1" or "--:--". (Refer to box on lower left
		of page.)

●Auto channel set function takes place first; it assigns automatically all receivable stations in your area.

●Auto clock set function sets the clock automatically by reading the clock setting data from a station transmitting a PDC signal while auto channel set is being performed.

●During auto channel set, the recorder recognizes each station name of the detected stations and stores them in the recorder's memory, then automatically sets SHOWVIEW assigned Guide Program number for those stations according to the broadcast area.

NOTE:

In the area where no TV station transmits a PDC signal, the recorder can perform neither auto clock set nor auto Guide Program number set.

NOTES:

●If you are using the on- screen display, the AUTO

SET screen will appear after				AUTO SET
pressing OK in step 4. As			PLEASE WAIT
Auto Set Up progresses, the
"	" mark on the screen	0	+		+	+
moves from left to right.

●If there is a power cut, or if

you press	or MENU		[MENU] : EXIT
while Auto Set Up is in
progress, Auto Set Up will		Beginning		End
be interrupted; be sure to

turn off the recorder power once and try again from step 1.