JVC HR-J580EK manual Check the Results, Finish Off

three step quick start

13

Check the Results

When Auto Setup or Preset Download has finished, you will see one of the two following examples on the VCR display panel:

The Preset Positions have been set successfully

Perform Clock Set on page 49.

Go to Step 3.

The Preset Positions have not been set successfully

Make sure the cables are connected properly to the VCR and turn the VCR off and then on again. Try Auto Set Up or Preset Download again. Then, perform Clock Set on page 49.

Finish Off

					ENTE
					R/EN
						TR
					3	EE
		MENU				OK
				TV	PR +
T						+
V
	–					V
						T
				TV	PR –
	TV
		TV/VCR AUDIO		– –:– –
	1	2		3
				2
	4	5		6
	VPS/PDC	DAILY/QTDN. WEEKLY/HEBDO
	7	8		9
	0000	AUX		4
		0
	START	STOP
	DEBUT	FIN DATE		PR
		EXPRESS
1	PROG	?		30 SEC
		ENTER/ENTREE
	MENU		3	OK
		TV PR	+
	T			+
	V
	–			TV
		TV PR	–

Select the Video channel or AV mode, then make sure that all necessary stations have been stored in the VCRÕs memory by using the Aand Bbuttons.

If station names (ID Ñ ☞ pg. 47) have also been stored in the VCRÕs memory, the station name will be displayed at the top left corner of the TV screen for about 5 seconds each time you select a different channel via the VCR.

The VCR is now set up. You can now use it to play and record.

IMPORTANT

¥re-running setup Auto Setup or Preset Download may not behave as described if it has already been run on the VCR. This is because some of the information gathered on the first Auto Setup or Preset Download is retained in memory and that part of the process may be skipped by the VCR.

¥duplicate stations You may be able to receive the same station from two different transmitters in which case Auto Setup will detect and store both. It is normal for one transmitter to give you a better quality picture than the other; to delete those stations which have a poor picture ☞ Delete A Channel on pageÊ45.

¥manual station setting If any of the above problems occur, refer to pageÊ45 to input station names (☞ Change Station Name). You can also change station preset positions (☞ pg.Ê46, Change Station Preset Position).

¥rf connections In certain reception conditions, the Video Channel may not be set correctly and interference may appear in the TV picture while the VCRÕs power is on. Set your Video Channel manually. (☞ pg.Ê42, Video Channel Set)

IF YOU HAVE ANY DIFFICULTY WITH THE ABOVE PROCEDURES CALL THE JVC CUSTOMER SERVICE HOT LINE ON 0870 330 5000