JVC HR-672, HR-J670, HR-671, HR-674, HR-272EU, HR-673, HR-470, HR-472EU 38 EN, For Example

38 EN	SUBSIDIARY SETTINGS (cont.)
	* The default setting is bold in the table below.
8 AUTO SP]LP TIMER	When this function is set to “ON”, the recorder
(HR-J670/671/672/673/674/470/472EU only)	automatically switches to LP mode to allow complete
ON	recording if there is not enough tape to record the entire
OFF	programme while timer-recording in SP mode.
	For Example . . .
	Recording a programme of 210 minutes in length onto a
	180-minute tape
	Approximately 150 minutes	Approximately 60 minutes
	SP mode	LP mode
	Total 210	minutes
	Make sure you set this function to “ON”, before the timer-
	recording starts.
	NOTES:
	● If you have programmed the recorder to timer-record 2 or more
	programmes, the second programme and those thereafter may
	not fit on the tape if you set “AUTO SP]LP TIMER” to “ON”. In
	this case, make sure the mode is not engaged, then set the tape
	speed manually during timer programming.
	● In order to ensure that the recording fits on the tape, this feature
	may leave a slight non-recorded section at the end of the tape.
	● There may be some noise and sound disturbance at the point on
	the tape where the recorder switches from SP to LP mode.
	● The Auto SP]LP Timer feature is not available during ITR
	(Instant Timer Recording), and the feature will not work properly
	with any tapes longer than E-180, or with some tapes of shorter
	lengths.
	● If you perform timer recording with both VPS/PDC and the Auto
	SP]LP Timer activated, and the programme goes beyond its
	originally scheduled length, there may be times when the
	programme cannot be recorded in its entirety.
8 POWER SAVE	When this function is set to “ON”, you can reduce the
ON	power consumption while the recorder is turned off.
OFF	NOTES:
	● During Power Save mode ...
	... the front display panel will be turned off.
	... the Just Clock function ( pg. 48) does not work.
	... the picture may be distorted momentarily when you turn on/
	off the recorder.
	● Power Save does not work when ...
	... the recorder is in the Timer mode.
	... the recorder’s power is turned off after timer-recording or
	Instant Timer Recording.
	... the Auto Satellite Programme Recording mode is engaged
	( pg. 30).
	... “L-2 SELECT” is set to “DECODER” or “SAT” ( pg. 39).