Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

STOP/EJECT

TEST SIGNAL

The channel on which the screen to the left appear clearly in step 3 is your Video Channel.

To view picture signals from the video recorder, set your TV to the Video Channel.

Be sure to connect the power plug to an AC outlet first before installing the lithium battery; otherwise, the battery's service life will be drastically shortened.

EN5

The video recorder is designed to send picture and sound signals via the connected RF cable to your TV on UHF channel 36. After you have turned on the recorder, set your TV to UHF channel 36, fine-tune as necessary, and check if picture and sound being received from the recorder come out clearly or not:

● If clear enough	you don't have to perform the following
	steps. Go to "Installing/Removing the
	lithium battery" on this page.
● If not	UHF channel 36 or neighbouring channels
	may be occupied by local stations. Perform
	the following steps to change the Video
	Channel to another channel between 32 – 40.

Before starting, make sure of the following:

●The recorder's power should be off.

●No cassette should be inserted in the recorder.

●The connected TV's power should be on.

1		SET TV CHANNEL
		Set your TV to a channel between 32 and 40 that you
		want to use as the Video Channel on the TV.
		BRING TEST SIGNAL ON
2		SCREEN
		Hold down the recorder's STOP/EJECT button for more
		than 5 seconds.

		● "– OUT" appears on the display panel.

3		TUNE YOUR RECORDER
		Turn the RF output channel adjustment screw on the
		rear panel of the recorder by using a screwdriver until
		the two vertical bars become as clear as they can be.
		EXIT VIDEO CHANNEL SET
4		MODE
		Press the recorder's STOP/EJECT button again to finish
		the setting.

Installing/Removing the lithium battery

1Make sure that the power plug is connected to an AC outlet and turn off the VCR power.

2Open the battery cover while pressing the release tab as illustrated.

3Insert a lithium battery with the plus (+) side up and push it in.

●To remove the lithium battery, press the latch A down- ward using a pointed non-metallic object, then pull out the lithium battery.

4Close the battery cover until it clicks in place.