JVC HR-J647MS, HR-J747MS specifications Activate Index Search, SET Counter Memory, Activate Counter

				E	N	13
Index Search		Next Function Memory
Your recorder automatically marks	£ 2	You can set your recorder's power to go off automatically after
index codes at the beginning of		the tape is fully rewound. Before starting, make sure the
each recording. This function gives		recorder is in the Stop mode.
you quick access to any one of 9		For Automatic Power Off After Tape Rewind . . .
index codes in either direction.		. . . press REW, then press	within 2 seconds.

NOTE:

Before starting, make sure the recorder is in the Stop mode.

ACTIVATE INDEX SEARCH

1 Press PUSH JOG Þ or %(ª or £) on the remote control. “ª 1” or “£ 1” is displayed on screen and search begins in the corresponding direction.

●To access index codes 2 through 9, press PUSH JOG

Þor % repeatedly until the correct index number is displayed.

Ex.: To locate the beginning of B from the current position, press PUSH JOG Þtwice.

To locate the beginning of D from the current position, press PUSH JOG %once.

Current position

A	B		C	D	E		F
–2		–1	1	2		3
		%		%

Index number

●When the specified index code is located, playback begins automatically.

NOTE:

If you want the power to be turned off automatically when the counter reads “0:00:00” (instead of at the beginning of the tape), press C. MEMORY so that the “M” mark appears before pressing REW.

Counter Memory

Returns to the counter reading of “0:00:00” to conveniently find a specific place on the tape automatically.

1	SET COUNTER MEMORY
	Press C. RESET during playback at a point you wish to
	locate later. The counter reads “0:00:00”. Then press
	C. MEMORY, and “M” appears in front of the counter
	digits.

	ACTIVATE COUNTER
2	MEMORY
	When you wish to return to the designated point, press
	STOP and then REW or FF.
	● The tape rewinds or fast-forwards and stops at about
	0:00:00 automatically.
	● To cancel Counter Memory, press C. MEMORY again.

Instant ReView

Simply by pressing a single button, the recorder power comes on, rewinds, and begins playback of the last timer-recorded programme. If you have several programmes recorded, you can easily access any of them.

NOTE:

Before starting, make sure that the recorder is off and that the Timer mode is disengaged.

1

ACTIVATE INSTANT

REVIEW

Press REVIEW. The recorder power comes on and the recorder searches for the index code indicating the start of the last timer-recorded programme. Once it’s found, playback begins automatically.

The front display panel tells you how many programmes have been recorded. If you have, for example, 3 programmes, “REVIEW” and "3" appear and blink. To watch the first of the 3 programmes, press REVIEW three times. The recorder searches and begins playback automatically. You can access a programme as far as 9 index codes away from the current tape position.

NOTE:

Instant ReView is not possible while the recorder is in the Timer mode.