JVC HR-S3800U DBS Receiver Brand Setting, 52 EN, Turn on the DBS receiver, Operate DBS receiver

52 EN MULTI-BRAND REMOTE CONTROL (cont.)

DBS Receiver Brand Setting

This Remote can control some functions of the DBS (Direct Broadcast Satellite) receivers listed below.

1	Turn on the DBS receiver
	Turn on the DBS receiver using the Power button
	on the DBS receiver or its Remote.
2
	Enter DBS receiver brand code
	Follow the example shown below.
	1 Press and hold CABLE/DBS.

2 –1 4

CABLE/DBS 1

4

7

1

POWER

2	3		2 –2
			2 –3
		2
5	6
8	9		Number
0		4

3 2 –4

ENTER

	2	Press MBR SET.
	3	Press the Number keys to enter your DBS
		receiver’s brand code by referring to the table
		below.
	4	Press OK, and release CABLE/DBS.
		The DBS receiver should turn off. If it does, try
		other operations below (Z step 3).
	c Once you have set the Remote to operate the
		DBS receiver, you do not have to set it until you
		replace the batteries from the Remote.
3
	Operate DBS receiver
	While holding down CABLE/DBS, press one of

the following buttons: POWER, TV CH +/Ð, and Number keys.

c For some brands, you must press ENTER after having pressed the Number keys to enter a channel number.

c To change the DBS receiver’s channels, press TV CH +/Ð or the Number keys. (The CH +/Ð button can be used to change the VCR’s

TV CH +/–

channels only.)

DBS BRAND NAME	BRAND CODE
JVC (DISH Network)	51
ECHOSTAR (DISH Network)	51
PRIMESTAR	50
SONY (DSS)	41
RCA (DSS)	40

NOTES:

c Depending on the type of DBS receiver, some or all functions cannot be operated using this Remote.

c It’s not possible to operate a DBS receiver not equipped with a remote sensor.

c It's not possible to set the Remote for both your DBS receiver and a cable box at the same time. You can only set the Remote to operate one of these units at a time.

(Ex.) To set the Remote to JVC 51:

CABLE/	MBR SET
DBS	A/B		E
			NTER/O
	5	1		SD	Release
			3	OK
Hold	Press in succession
down

HR-S4800U/S3800U-EN44-53 52 00.1.31, 10:03 AM