|
|
| EN 55 | |
Changing |
| another set to respond to B code control signals. | ||
|
| This Remote is capable of transmitting two control | ||
Remote Control | codes; one set to respond to A code control signals and | |||
signals. You can easily modify your VCR and the Remote | ||||
| 2 | This Remote control is preset to send A code signals | ||
Code | because your VCR is initially set to respond to A code | |||
to respond to B code signals. | ||||
| ||||
| When using two JVC VCRs, set two VCRs and their | |||
| Remotes to different codes, so that you can operate these | |||
| VCRs1separately. | |||
|
|
|
|
POWER
REC LINK
S VIDEO | VIDEO |
REW | FF |
– | + |
PUSH / TURN
A.DUB
24HR QUICK
PROGRAM
INSERT | REC | PAUSE | STOP/EJECT |
1Set remote control code for Remote
2Press and hold A/B.
3Press the Number key “2”. Press OK, and release A/B.
●The Remote now can transmit B code control
2signals.
1 2 3
4 5 6
7 8 9
0
2
4
1
1
Check remote control code for VCR
Press and hold 3 on the VCR for more than
5 seconds while the VCR is turned off. The code
3currently set appears on the display panel.
Change code for VCR
Press any key on the Remote.
●The VCR now responds to B code control signals.
●To set the Remote and the VCR back to A code control signals, repeat the same procedure as shown above except pressing the Number key “1” in step 2of 1.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote control1 code for the Remote between A and B ( step
), keeping two VCRs to different control codes.
1
●Press the Number key “1” for A code control signals and the Number key “2” for B code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 2and 3.)
3
(Ex.) To set Remote to B code:
MBR SET |
|
|
|
|
A/B |
| E |
|
|
|
|
|
| |
|
| NTER/O |
| |
| 2 |
| SD | Release |
| 3 | OK | ||
Hold | Press in succession | |||
down |
|
|
|
|