Before Requesting Service
Make sure by first checking the following points.
| SYMPTOM | CAUSE | POSSIBLE SOLUTION |
|
|
|
|
| POWER |
|
|
|
|
|
|
| No power. | The AC power cord is not connected. | Connect the AC power cord to the AC |
|
|
| outlet. |
| Although the power is on, it | Cassette is not inserted. | Insert a video cassette. |
| does not operate. |
|
|
| TV BROADCAST RECEPTION |
|
|
|
|
|
|
|
| Antenna connection is not correct. | Connect it correctly. |
|
|
|
|
|
| Antenna cable is disconnected. | Reconnect the antenna cable. |
|
|
|
|
|
| The video channel is not in the correct | Set it to CH 3 or 4. |
| A TV program that is selected by | position. |
|
| the VCR does not appear on the | The TV is not set to the video channel | Set the TV channel selector to the 3 or 4 |
| screen. | 3 or 4. | position. |
|
|
|
|
|
| The TV/VCR selector is set at TV mode | Press the TV/VCR selector button (The TV/ |
|
| (The TV/VCR indicator is not lit). | VCR indicator will light). |
|
| INPUT is set to the LINE mode. | Press the Number key or CH |
|
|
| select your desired TV program. |
|
|
|
|
| RECORDING |
|
|
|
|
|
|
|
| The erase prevention tab of the video | Place a piece of vinyl tape over the gap. |
| TV recording does not work. | cassette is broken off. |
|
| INPUT is set to the LINE mode. | Press the Number key or CH | |
|
| ||
|
|
| select your desired TV program. |
|
| The time is not set correctly. | Reset the present time. |
| Timer recording does not work. | The recording start/end time is not set | Set the start/end time. |
| correctly. |
| |
|
| The TIMER button has not been | Press the TIMER button (The TIMER |
|
| pressed (The TIMER indicator is not lit). | indicator is lit). |
|
|
|
|
| PLAYBACK |
|
|
| No picture on screen when | The TV is not set to the video channel 3 | Set to the video channel 3 or 4 or |
| playing back a recorded tape. | or 4. | adjust the fine tuning button on your |
|
|
| TV set. |
|
| Tracking adjustment beyond range of | Adjust tracking manually using the SET – or |
| Noise bars on screen. | automatic tracking circuit. | + buttons on the remote control. |
| Video heads are dirty. | Have the video heads cleaned. | |
|
| ||
|
| The tape is worn or damaged. | Try another tape. |
| REMOTE CONTROL |
|
|
|
|
|
|
|
| It is not aimed at the remote sensor. | Aim it at the remote sensor. |
|
| Distance too far or too much light in | Operate within 15 feet (5 meters) reduce |
|
| the room. | the light in the room. |
|
|
|
|
| Remote control does not work. | There is an obstacle in the path of the | Clear the path of the beam. |
| beam. |
| |
|
|
| |
|
| The batteries are weak. | Replace the batteries. |
|
| The +, – polarity of the batteries are | Insert correctly. |
|
| not inserted correctly. |
|
| TV programs cannot be seen | The TV/VCR function is in the VCR | Set to TV, or turn off the VCR power |
| using the TV selector. | mode. | button. |
|
|
|
|