JVC HR-VP436U manual Instant Timer Recording ITR, On-Screen Timer Programming, Engage ITR Mode

36TIMERRECORDING(cont.)

Instant Timer Recording (ITR)

2	2
q	5/8 6
	REC
I T R	R E C

VIDEO SP

This easy method lets you record for from 30 minutes to 6 hours (selectable in 30-min. increments), and shuts the VCR off after recording is finished.

START RECORDING

1 Press REC.

ENGAGE ITR MODE

2 Press REC again. ITR blinks and 0:30 appears on the front display panel.

SET RECORDING

DURATION

3 If you want to record for more than 30 minutes, press REC to extend the time. Each press extends recording time by 30 minutes.

NOTES:

●You can only perform ITR using the REC button on the VCR's front panel.

●After you set the time, the previous display reappears.

●To check remaining recording time, press REC once during recording and the remaining time is displayed for about 5 seconds. Be careful not to press again during this 5 seconds, or you’ll add 30 more minutes to the recording.

On-Screen

Timer

Programming

* Refer to the illustration on page 37.

You can directly program the VCR’s timer to record up to 8 shows, as far as a year in advance. Remember, the clock must be set before you can program the timer (☞ pg. 7 or 8).

LOAD A CASSETTE

1 Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load.

●The VCR comes on, and the counter is reset, automatically.

ACCESS PROGRAM SET SCREEN

Press MENU as many	PROGRAM 1
times as necessary to bring
	START	- - : - - AM
2 up the Main Menu screen,
	DATE	- - / - -
then press OK.	STOP	- - : - - AM
	CHANNEL	- - SP
	PRESS NUMBER KEY(0-9)
	OR (5,°), THEN (OK)
	PRESS (MENU) TO END