JVC HR-J435EA specifications SET Counter Memory, Activate Counter, Activate Intelligent, Picture

Tape Position Indicator

The tape position indicator appears
on screen when, from the Stop
mode, you press FF, REW or
perform an Index Search. The
position of “5” in relation to “0”			3
(beginning) or “+” (end) shows you	0	+		+	+
where you are on the tape.					1:23:45

”O.S.D.” (☞ pg. 5) must be set to “ON”, or the indicator will not appear.

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.

Counter Memory

Returns to the counter reading of “0:00:00” to conveniently find a specific place on the tape automatically.

1	SET COUNTER MEMORY
	Press C. RESET during playback at a point you wish to
	locate later. The counter reads “0:00:00”. Then press C.
	MEMORY, and “M” appears on the front display panel.

	ACTIVATE COUNTER
2	MEMORY
	When you wish to return to the designated point, press
	STOP and then REW or FF.
	● The tape rewinds or fast-forwards and stops at about
	0:00:00 automatically.
	● To cancel Counter Memory, press C.MEMORY again.

Intelligent Picture

To get a better picture when viewing tapes with noise such as rental tapes. Useful for normal playback of SP(or LP)-mode recorded tapes as well.

	ACTIVATE INTELLIGENT
1	PICTURE
	During playback or stop, press PICTURE.
	● lights.The INTELLIGENT PICTURE indicator on the recorder
	● To turn it off, press PICTURE again.
	● Intelligent Picture is not effective during search, slow,
	still, or frame-by-frame playback even though the
	INTELLIGENT PICTURE indicator on the recorder
	lights.

13

Index Search

Your recorder automatically marks

index codes at the beginning of£ 2 each recording. This function gives

you quick access to any one of 9 index codes in either direction.

NOTE:

Before starting, make sure the recorder is in the Stop mode.

ACTIVATE INDEX SEARCH

1 Press PUSH JOG ª or £. “ª 1” or “£ 1” is displayed on screen and search begins in the corre- sponding direction.

●To access index codes 2 through 9, press PUSH JOG ª or £ repeatedly until the correct index number is displayed.

Ex.: To locate the beginning of B from the current position, press PUSH JOG ª twice.

To locate the beginning of D from the current position, press PUSH JOG £ once.

Current position

A	B		C	D		E		F
–2		–1	1		2		3
		ª £
						Index			number

●When the specified index code is located, playback begins automatically.

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can play back NTSC tapes.

1	LOAD A CASSETTE
	Insert a cassette recorded in NTSC.
2	START PLAYBACK
	Press PLAY.
	● Some TVs shrink the picture vertically and place
	black bars at the top and bottom of the screen. This is
	not a malfunction on the part of either the video
	recorder or the TV.
	● The picture may roll up and down. This can be
	corrected using the V-HOLD control found on some
	TVs. (This cannot be corrected if the TV does not
	have a V-HOLD control.)
	● The counter and tape remaining time readings will be
	incorrect.
	● During search, still, or frame-by-frame playback, the
	picture will be distorted, and there may be a loss of
	colour.