JVC HR-J435EA Tune The TV To Your Video Recorder, Select Output Mode, SET TV Channel, Back of VCR

Page 4

INSTALLINGYOURNEWRECORDER (cont.)

Tune The TV

2 3

q 5/8 6

OPERATE

The video recorder sends picture and sound signals via the RF connecting cable to your TV on UHF channel 37.

1		TURN ON THE RECORDER
1		Press OPERATE.
2		SELECT OUTPUT MODE
2		Set the TEST switch on the back of the recorder to ON.
3		SET TV CHANNEL
		Set your TV to the video channel (UHF channel 37).
		Two white bars appear on screen vertically.
		● Tune the TV until the bars are as clear as they can be.
		● Tune the TV until the bars are as clear as they can be.
		● Your TV should be set to the channel designated for
		use with a video recorder, or to a spare channel if
		there is not a specified video channel on your TV.

4		RESET OUTPUT MODE
4		Return the TEST switch to OFF.

NOTES:

●If CH37 is occupied by a local station, adjust the RF output channel adjustment screw to use another channel between CH33 and CH41 instead.

●If some interference noise is continually seen on the screen, consult your JVC dealer.

Image 4

Contents HR-J435EA Safety Precautions Do not place the recorderCheck Contents Basic ConnectionsSituate Recorder Connect Recorder to MainsSelect Output Mode Reset Output ModeTune The TV To Your Video Recorder SET TV ChannelAccess O.S.D. SET ENABLE/DISABLE ON-SCREEN DisplayClose Mode Select Screen On-Screen DisplaysAccess Channel SET Mode Select ScreenTuner Set Turn on the RecorderSelect Mode Select PositionStore Channel Select ChannelFine-Tuning Channels Already Stored Perform TuningReturn to Normal Clock Set SET TimeSET Date SET YearBasic Playback Load a CassettePoint Start PlaybackPlayback Features Activate Instant Review Activate RepeatInstant ReView Repeat PlaybackSET Counter Memory Activate CounterMemory Activate IntelligentBasic Recording Recording Features Code Setup Access Channel SET Mode Select ScreenPress OK Guide Prog Input Guide Prog NumberNumber starts blinking Code Timer Programming Access G-CODE ScreenEngage Timer Mode Enter G-CODE NumberTimer Enter Programme Stop Regular Timer ProgrammingTime Timer Mode TimerEngage RECORDER’S Select ProgrammeSET Recording DECK’S Input Mode Edit To Or From Another Video RecorderMake Connections Start Source PlayerSET RECORDER’S Input Mode Edit From a CamcorderStart Camcorder Start RecorderTroubleshooting Timer Recording Timer againQuestions and Answers Index Display Panel How To Use Installing BatteriesOperating JVC TVs Specificat Ions HR-J435EA