JVC HR-V610AJ, HR-V610AA Tuner Setting, Tape-To-Tape Editing, Manual Channel Set Auto Channel Set

– Information on Multi-System Compatibility –

Tape-To-Tape Editing

There are 4 different types of recorded tape, depending on the signal recorded.

Recorded tape Playback equipment Dubbed tape

Recording circuit

Tuner Setting

IMPORTANT

Perform the following steps only if auto channel set has not been set correctly by Auto Set Up function or if you have moved to a different area or if a new station starts broadcasting in your area.

Your recorder needs to memorise all necessary stations in channel positions in order to record TV programmes. Auto Channel Set automatically assigns all receivable stations in your area so that you can call them up with the PR+/– buttons without going through any vacant channels.

IMPORTANT

●If no sound accompanies the picture or the audio sounds unnatural on some channels that have been stored by Auto Channel Set, the TV system setting for those channels may be incorrect. Select the appropriate TV system for those channels.

Refer to “TV System Selection — When you see the picture but the audio can’t be heard or sounds unnatural” ( 15).

●Since your recorder memorises all detected stations even if the reception condition is poor, some of those stored stations may

produce a noisy picture. To delete those stations, refer to “Delete A Channel” ( 15).

Manual Channel Set

Auto Channel Set

AAccess Main Menu screen, then Tuner

Set screen

Press MENU on the remote control. Press rt to place the pointer next to “TUNER SET”, then press OK or e.

MAIN MENU

FUNCTION SET TUNER SET

INITIAL SET

[ /] [MENU] : EXIT

Store channels that were not stored during Auto Set Up or Auto Channel Set.

AAccess Tuner Set screen

Perform step A of “Auto Channel Set”.

BAccess channel list

Press rt to place the pointer next to “CH EDIT”, then press OK or e.

BPerform Auto Channel Set

Press rt to place the pointer next to “AUTO CH SET”, then press OK or e.

CSelect TV system

Press rt to place the pointer next to the appropriate TV system, then press OK or e.

●Auto Channel Set will start.

TUNER SET

CH EDIT

AUTO CH SET

[ /] [MENU] : EXIT

TV SYSTEM SELECT

B/G

D/K

I

M

[ /] [MENU] : EXIT

CSelect position

Press rt to place the pointer next to an open channel position, then press OK or e.

DSelect band

Press rt to place the pointer next to the band of your choice, then press OK to initiate Manual Channel Set.

BAND SELECT	MANUAL CH SET
VHF L	PLEASE WAIT
VHF H
UHF	VHF L 300MHZ

	AUTO CH SET
	PLEASE WAIT
START	FINISH

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ – – – – – – –

* M: For HR-V610AJ only

CH	FRQ	SYS	CH	FRQ	SYS
01	150	BG	07	229	BG
02	165	BG	08	237	BG
03	195	BG	09	355	BG
04	205	BG	10	365	BG
05	213	BG	11	374	BG
06	221	BG	12	384	BG

[	/	]	[	] : DELETE
[	/	]		: EDIT
[MENU] : EXIT

[ / ]	[MENU] : EXIT
[MENU] : EXIT

Press MENU to return to normal screen.

— 14 —