JVC HR-J250E After Scan Completed Is displayed on the screen, For about 5 seconds, Screen channel

1 2 3

2

4 5 6

7 8 9

0 4

1 ?

OK

MENU

EN23

	VIEW CONFIRMATION
4	SCREEN
	After "SCAN COMPLETED"	PR	CH	ID	PR	CH	ID
	is displayed on the screen	01	25	– – – –	07	C33	– – – –
	for about 5 seconds, the	02	C08	– – – –	08	C26	– – – –
		03	10	– – – –	09	55 – – – –
	Confirmation screen	04	C65	– – – –	10	C24	– – – –
	looking like the one to the	05	C31	– – – –	11	C23	– – – –
		06	C32	– – – –	12	C25	– – – –
	right appears. The stations
		[5°]
	your recorder located
		=		: EDIT
	appear on a Confirmation
		= [X] : DELETE
	screen — channel	[MENU] : EXIT
	positions (PR) and			C: Cable
	channels (CH).
	The blueback screen and the program currently being
	broadcast by the blinking station appear alternately for
	8 seconds each.
	To view the next page, use the %Þbutton on the
	remote control.

		RETURN TO NORMAL
5		SCREEN
	Press MENU.
		● Using the Confirmation screen, you can skip or add
		channel positions, enter station names and perform
		other operations. Refer to pages 24 – 26 for the
		procedures.

IMPORTANT

Your video recorder memorizes all detected stations even if reception of some of them is poor. In these cases picture quality may be poor. To delete those stations with an unacceptable picture ☞ "Delete A Channel" on page 25.

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you want to perform it manually, refer to page 25.

●If you perform Auto Channel Set when the aerial cable is not connected properly, "SCAN COMPLETED -NO SIGNAL-" appears on the screen in step 4. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.