Go-Video DP7040, DP8440 manual Disc Handling & Maintenance, Troubleshooting the Optional Tuner

Page 31

Disc Handling & Maintenance

Handling Precautions

Hold the disc by the edges so the surface will not be

soiled with fi ngerprints.

• Fingerprints, dirt and scratches can cause skipping and distortion.

Do not write on the label side with a ball-point pen or other writing utensil.

Do not use record cleaning

sprays, benzine, thinner, static electricity prevention liquids, or any other solvent.

Be careful not to drop or bend the disc.

Do not install more than one disc on the disc tray.

Do not try to close the disc cover when the disc is not installed properly.

Be sure to store the disc in its original case when not in use.

If the surface is soiled

• Wipe gently with a soft, damp (water only) cloth.

• When wiping discs, always move the cloth from the center hole toward the outer edge. (If you wipe the disc using a circular motion, circular scratches are likely to occur, which will cause noise.)

If the disc is brought from a cold to a warm environment, moisture may form on the disc

Wipe moisture off with a soft, dry, lint-free cloth before using the disc.

Improper disc storage

You can damage discs if you store them in the following places:

Areas exposed to direct sunlight

Humid or dusty areas

Areas directly exposed to a heat outlet or heating appliance

Disc which cannot be played with this player

CD-ROM (Application Program)

CVD

CD-G

DVD with a Region Code other than that shown on the DVD unit’s Region Code Label on the rear panel

Maintenance

Be sure to turn the unit off and disconnect the AC power cord before maintenancing the unit.

Wipe this unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth which has been dipped in a weak soap-and-water solution and wrung out thoroughly, and then wipe again with a dry cloth.

Never use alcohol, benzine, thinner, cleaning fl uid or other chemicals. And do not use compressed air to remove dust.

Troubleshooting the Optional Tuner

SYMPTOM

REMEDY

Angle cannot change.

• Depends on software availability. Even if a disc has a number of angles recorded, these

 

angles may be recorded for specifi c scenes only.

No picture with tuner

• Make sure the antenna and tuner are connected.

 

• Make sure Tuner is selected as the signal source by pressing the Mode button.

 

• Make sure Cable / Antenna is set to match the source of the signal by pressing the Menu

 

button in Tuner mode.

Picture quality poor with

• Make sure the antenna connections are correct and that the Tuner support pin is also

tuner

connected.

 

• Adjust the antenna position for better picture

 

• Move the DVD player away from any interfering device.

31

Image 31
Contents Page Table of Contents Macrovision Notice FCC and Safety InformationRegion Codes Important Safety Instructions Open Disc Tray Opens the disc tray Player OverviewFront View Close Disc Tray Press here to close the disc trayFront Left Side Right Side Other ViewsInserting Remote Control Batteries Remote ControlQuick Start Removing the Battery Pack Battery Pack OverviewCharging the Battery Pack Charging the Battery Pack DirectlyVideo Connections ConnectionsBasic TV Connections Enhanced Video ConnectionsDigital Audio Connections Enhanced Audio ConnectionsExternal Device Connections Analog Audio ConnectionsViewing Disc Menus DVD PlaybackBefore You Begin Basic DVD PlaybackPause Forward/Reverse ScanRepeat Skip Next/PreviousSubtitles Special DVD FeaturesDisplaying Scene Information AudioDisc Menu AngleMute TitlePlaying Audio CDs Other Disc PlaybackPlayback Modes Playing Kodak Picture CDsPlaying Jpeg Picture CDs File Manager ModeProgramming MP3 CDs Playing MP3 CDsPlaying CDs with MP3 and Jpeg files Browsing DirectoriesOn Screen Display OSD Language Language SetupDisc Menu Language Subtitle Language DVD Audio Language DVDTV System Screen/TV Tuner SetupTV Type Screen SaverVideo Output Press  /  to select the appropriate Country settingCountry Press  /  to select Digital Out, then press Audio SetupPress  /  to select your preferred Digital Out setting Digital Audio Output DVDParental Control DVD Custom SetupChange Password DVD Press  /  to select Password, then pressAngle Mark DVD Restore DefaultsLCD Setup Using the RF Adapter Using the Optional DPT100 TunerConnecting the Tuner Using the AntennaAuto search Fine Tuning ChannelsSearching for Channels FreqSymptom Remedy TroubleshootingTroubleshooting the Optional Tuner Disc Handling & MaintenanceIncluded Accessories Parts & AccessoriesLimited Warranty