JVC LPT0679-001B Turn on the recorder, Perform Auto Set Up, On the front display panel

INITIAL SETTINGS 13

Auto Set Up

Auto Channel Set/Auto Clock Set/ Auto Guide Program Number Set

After the 1 button on the recorder or remote control is pressed for the first time to power on the recorder, the Auto Set Up function sets the tuner channels, clock and Guide Program numbers automatically.

1

2

1	2	3
4	5	6	3
7	8	9	4
			4

0

1	3
2

ATTENTION

Once you have performed Auto Set Up, even if the recorder’s memory backup has expired, all the stored stations and their Guide Program numbers remain in the recorder’s memory and the recorder will not perform Auto Set Up again. You only need to set the clock. ( pg. 80)

If you have moved to a different area, perform each setting as required.

●Tuner setting  pg. 72

●Clock setting  pg. 80

If a new station starts broadcasting in your area, perform tuner setting ( pg. 72).

Before starting, make sure of the following:

●The TV aerial cable should be connected to the recorder.

●The recorder’s mains power cord should be connected to a mains outlet.

●If you want to use the on-screen display, the TV should be set to its AV mode.

A Turn on the recorder.

Press 1 on the recorder or remote control.

B Perform Auto Set Up.

The AUTO SET/T-V LINK display appears on the front display panel and/or on the TV screen.

On the front display panel

Press rt to select “Auto” and press OK or e.

On the on-screen display Press rt to move the highlight bar (pointer) to “AUTO SET” and press OK or e.

“Auto” blinks on the front display panel; do NOT press any button on the recorder or remote control until the front display panel shows clock time, “(CH) 1” or

“– –:– –” as illustrated on page 15.

●If you are using the on-screen display, the AUTO SET

screen will appear. As Auto
Set Up progresses, the “q”
mark on the TV screen
moves from left to right.
When the Auto Set Up is
completed, “SCAN
COMPLETED” appears for
about 5 seconds, then the	Beginning	End
normal screen appears.

●When you have connected the video recorder to a TV offering T-V Link via a fully-wired 21-pin SCART cable ( pg. 11) and

the TV is turned on, the recorder automatically performs the Preset Download ( pg. 14) even if you select “Auto” for Auto Set Up function.

NOTES:

●In the area where no TV station transmits a PDC (Programme Delivery Control) signal, the recorder can perform neither Auto Clock Set nor Auto Guide Program Number Set.

●If there is a power cut, or if you press 1 or MENU while Auto Set Up is in progress, Auto Set Up will be interrupted; be sure to turn off the recorder power once and try again from step 1.

●Auto Clock Set may not function properly depending on the reception condition.