JVC LPT0617-001A, HR-DVS3EK Recording cannot be started, There is no cassette loaded, or

84			TROUBLESHOOTING (cont.)
RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Recording cannot be started.	● For the VHS deck
		There is no cassette loaded, or the	Insert a VHS (or S-VHS) cassette, or using
		cassette loaded has had its record safety	adhesive tape, cover the hole where the
		tab removed.	tab was removed.
		● For the DV deck
		There is no cassette loaded, or the	Insert a Mini DV cassette, or set the erase
		cassette loaded has had its erase	protection switch set to “REC”.
		protection switch set to “SAVE”.
2.	TV broadcasts cannot be recorded.	● “L-1”, “L-2”, “F-1” or “SAT” has been	Set to the desired channel.
		selected as the input mode.
3.	Tape-to-tape editing is not possible.	● The source (another video recorder,	Confirm that the source is properly
		camcorder) has not been properly	connected.
		connected.
		● All necessary power switches have not	Confirm that all units’ power switches are
		been turned on.	turned on.
		● The input mode is not correct.	Set the input mode to “L-1”, “L-2” or
			“F-1”.
4.	Camcorder recording is not possible.	● The camcorder has not been properly	Confirm that the camcorder is properly
		connected.	connected.
		● The input mode is not correct.	Set the input mode to “L-1”, “L-2” or
			“F-1”.
5.	“[” on the front display panel won’t	● The end of the tape was reached during	The programme may not have been
	stop blinking.	recording.	recorded in its entirety. Next time make
			sure you have enough time on the tape to
			record the entire programme.
6.	Audio dubbing is not possible.	For the DV deck
		● “SOUND MODE” had been set to	Set “SOUND MODE” to “12BIT” at the
		“16BIT” at the original recording.	original recording. ( pg. 71)
		● The tape speed had been set to LP at the	Set the tape speed to SP at the original
		original recording.	recording.
7.	Monitoring the audio-dubbed sound is	● This is normal.	Set “12BIT MODE” to “SOUND 2” or
	not possible during audio dubbing		monitor the sound using the connected
	using the DV deck.		devices.
8.	The programmed memory of Random	● The memory backup time has expired.	Perform Random Assemble Editing again.
	Assemble Editing is disappeared.		( pg. 58)
9.	When performing Normal Dubbing,	● This is normal.	Locate the start point a little before the
	the beginning of the dubbing start		point where you want to start dubbing.
	point is not dubbed.		( pg. 46, 47)