JVC SR-VS20EK, LPT0543-001A setup guide Engage Insert Editing, Start Editing, END Insert Editing

STOP PAUSE SHUTTLE

INSERT	DUB	PLAY	JOG
	A.

1
2
1	2	3
4	5	6	3
7	8	9	4
			4
0000	0
1			3
2
			PLAY

STOP PAUSE

5

6

7

8

9

49

RESET THE COUNTER (VHS DECK ONLY)

Press 0000 to change the counter display to "0:00:00".

LOCATE START POINT

Determine the edit-in point (the beginning of the segment to be replaced) using the SHUTTLE ring or the JOG dial or pressing @# and PAUSE.

●Be sure to engage the Still mode at the edit-in point.

ENGAGE INSERT EDITING

Press INSERT.

●Your recorder enters the Insert-Pause mode. ("", "" and "" light up on the front display panel.)

●The TV screen changes from the still picture to the input source you are going to record.

START EDITING

Load the source cassette and play back the segment that is to be inserted. When you reach the start of the section of the source tape that you wish to insert, press PLAY to start the tape in your recorder; Insert Editing begins at this point.

●"" and "" are displayed on the front display panel.

END INSERT EDITING

VHS deck

At counter "0:00:00", Insert Editing will stop automati- cally while the tape continues running in the Play mode. If you wish to stop Insert Editing before the specified edit-out point, press 0000.

DV deck

Press STOP to stop the tape in the DV deck.

NOTES:

●Once the Insert Editing starts, you can not use the other deck.

●All necessary cables can be obtained from your dealer.

●Insert Editing cannot be performed on a VHS/S-VHS cassette that has had its record safety tab removed, or on a Mini DV cassette that has had its erase protection switch set to "SAVE".

●When Insert Editing is performed on a tape that has been recorded on another video recorder, the inserted portion may appear distorted.

●In Insert Editing, the recording speed (SP/LP) is determined by the previous recording to be replaced. If the previous recording's speed changes within a single edit, the inserted picture will be distorted at the switching point. (VHS deck only)

●A small portion of the recording which precedes an insert edit may be erased.

●Insert Editing is also possible using the rear panel AV1 (L-1) IN/OUT or AV2 (L-2) IN/DECODER connector. When using these connectors, make sure to select the correct input mode in step 3.

●Insert Editing is not possible using the DV IN/OUT connector.

FOR AV INSERT EDITING (VHS DECK ONLY)

If you want to replace the picture, Hi-Fi audio soundtrack and

normal audio soundtrack all at the same time...

... In step 7 above, after you press INSERT, press A. DUB also. ("" and "" blink and "" lights up on the front display panel.)