JVC LPT0543-001A Step Auto SET UP, Before performing the following procedure, make sure that

AUTO SET

PLEASE WAIT

8

QUICKSETUPGUIDE (cont.)

STEP

3

AUTO SET UP

SET THE TUNER CHANNELS, CLOCK AND GUIDE PROGRAM NUMBERS

The Auto Set Up function sets the tuner channels, clock and VIDEO Plus+ assigned Guide Program numbers automatically the first

time the button on the recorder or on the remote is pressed to turn on the recorder after the mains power cord has been plugged into a mains outlet.

Before performing the following procedure, make sure that:

the TV aerial cable is connected to the recorder.

the mains power cord is plugged into the mains outlet.

batteries have been installed in the remote control.

1

2

1

2

1	2	3
4	5	6	3
7	8	9	4
			4

0

1 3

Press to turn on the recorder.

If "Auto" appears on the display panel, press OK or #. "Auto" blinks; do NOT

press any button on the recorder or

remote control until the display panel shows either the display as illustrated on page 10 or "– – :– –". Auto Set Up usually takes about 4 – 12 minutes; the duration varies by area.

●If "– –:– –" appears on the display panel,

refer to page 10.

● If the TV is turned on and set to its AV mode, the AUTO SET screen will appear.

●When you have connected the video recorder to a TV offering T-V Link via the AV connec-

tion ( pg. 6) and the TV is turned on, the	0	+	+	+
recorder automatically performs the Preset
Download ( pg. 9) even if you select
	[MENU] : EXIT
"Auto" for Auto Set Up function.
					End
Beginning

2

3 Refer to page 10 to check the results.

ATTENTION

Once you have performed Auto Set Up, all the stored stations and Guide Program numbers remain in the recorder's memory and the recorder will not perform Auto Set Up again. If there is a power cut and the recorder's memory backup expires you only need to reset the clock. ( pg. 72)

If you have moved to a different area, perform each setting as required.

Tuner setting  pg. 64

Clock setting  pg. 72

If a new station begins broadcasting in your area, perform tuner setting ( pg. 64).

NOTES:

●Auto channel set function takes place first; it assigns automatically all receivable stations in your area.

●Auto clock set function sets the clock automatically.

●During auto channel set, the recorder recognizes each station name of the detected stations and stores them in the recorder's memory, then automatically sets the VIDEO Plus+ system assigned Guide Program numbers for those stations according to the broadcast area.

●If there is a power cut or if you press or MENU while Auto Set Up is in progress, Auto Set Up will be inter- rupted; be sure to turn off the recorder power once and

press to turn the power back on in order to re-start Auto Set Up.