JVC HR-J235EK Return to Normal, Engage RECORDER’S, Access Programme Screen, Press TV PROG. +

TIMER

6

						29
6	ENTER PRESET POSITION
	Press TV PROG. +/–.		PROGRAM 1
		START		STOP
		21 : 00		22	: 00
		SP			ON
		DATE		TV	PROG
		25. 12			1
		[+ –] : SET =			BBC1
				: OK

7 SP/LP

q

		SP
		DM
7	SET TAPE SPEED
	Press SP/LP to set the tape speed.
	● If you’re not receiving PDC (Programme Delivery Control),
	press NUMBER key “7” to set		to "OFF" (☞ pg. 30).
	RETURN TO NORMAL

NUMBER

1

4

7

2DAILY3

5 62

8 9 WEEKLY

SCREEN

After confirming all information is correct, press OK

8 and the normal screen appears.

CANCEL

START+/–

7 SP/LP

1

0 TIMER 9

		TV PROG. 6
STOP+/–		DATE+/
		–
		.CHECK
		PROG
	3	OK	8

● Repeat steps 1 – 8 for each additional programme.

ENGAGE RECORDER’S

TIMER MODE

9 Press TIMER.

To Timer-Record Weekly Or Daily Serials . . .

. . . anytime during steps 2 through 8, press WEEKLY (NUMBER key “9”) for weekly serials or DAILY (NUMBER key “8”) for daily serials (Monday – Friday).

Check And Cancel Programmes

ACCESS PROGRAMME

SCREEN

1 Press PROG CHECK. Each time you press the next program’s information appears.

NOTES:

●For safety, your recorder disables all other functions while in the Timer mode. If you want to use the recorder but its Timer mode is engaged, press TIMER and all other functions are operable. To re-engage the timer, press TIMER.

●You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen and "FULL" appears on the front display panel. To record the extra programme, you must first cancel any unnecessary programmes. (See "Check And Cancel Programmes" in the right column.)

●To timer-record a satellite broadcast through a satellite receiver connected to the AV2 IN connector on the back of the recorder, in step 6 above, set "TV PROG" to "AUX2" by pressing TV PROG. +/–. Before the selected programme begins, select the appropriate channel on the satellite receiver, then set the receiver's timer. If your satellite receiver doesn't have a timer, leave the unit's power switched on.

●Press OK and watch the front display panel as the Start and Stop times, the Date and the Preset position appear.

●If the recorder is turned on and the TV is set to its VIDEO mode, you can check program information on screen as well.

	If All Information Is Correct . . .
	. . . programming is completed.
	If You Wish To Revise Data . . .
	. . . with the recorder's power turned on, go to step 2.
	If You Wish To Cancel A Program . . .
.	. . . with the recorder's power turned on, press CANCEL.
	All information you input is deleted.

	REVISE PROGRAMME IN-
2	FORMATION
	Input the appropriate data using the START +/–, STOP +/–,
	DATE +/– and TV PROG. +/– buttons on the remote control.