Filename |
|
Masterpage:Left |
12 EN | INSTALLING YOUR NEW VCR |
Basic Connections
|
|
| Antenna or Cable | |
| Coaxial Cable |
| ||
|
| Flat Feeder | ||
| Matching Transformer | |||
| (not supplied) |
| ||
|
|
| AC Outlet | |
| VIDEO | AUDIO | AC | |
ANTENNA | OUT | OUT | ||
Power | ||||
IN |
|
| Cord | |
Back of VCR
ANTENNA
OUT
Audio/Video Cable (supplied)
It’s essential that your VCR be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
A Check the contents.
Make sure the package contains all of the accessories listed in “SPECIFICATIONS” on page 82.
B Situate the VCR.
Place the VCR on a stable, horizontal surface.
C Connect the VCR to TV.
ADisconnect the TV antenna from the TV.
BConnect the TV antenna cable to the ANTENNA IN connector on the rear panel of the VCR.
CConnect the supplied RF cable between the ANTENNA OUT connector on the rear panel of the VCR and the TV’s antenna terminal.
DConnect the supplied Audio/Video cable between the AUDIO/VIDEO OUT connectors on the rear of the
VCR and the Audio/Video input connectors on the TV.
●Set your TV to AV mode.
●For switching the TV’s mode, refer to the instruction manual of your television.
●To obtain
D Connect the VCR to power source.
Plug the end of the AC power cord into an AC outlet.
To Audio/Video
Input Connectors
RF Cable (supplied)
To 75 ohm Terminal
TV
●The clock and tuner channels will automatically be set when
the antenna is connected and when the AC power cord is first connected to an AC outlet ( pg. 14). (If “Auto” or “CH” is displayed on the front display panel before the VCR is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the VCR.)
Page 12
January 31, 2002 3:21 pm