JVC HR-DD949EE Access Jlip ID NO. SET Screen, SET Jlip ID Number, Return to Normal Screen

38EN

INFORMATIONONJTERMINAL

	J Terminal (JLIP(Joint Level
	Interface Protocol) Connector)
	The J Terminal is used to connect the recorder to a personal
	computer or similar device to allow computerized control of the
	recorder during editing and certain other operations.
	Examples:
	● Enables Random Assemble Editing of up to 99 segments with
	the optional JLIP PLAYER PACK, using this recorder as the
	playback unit. (Use this recorder's PAUSE connector in lieu of
J terminal	the EDIT jack.)
	● Allows you to capture still images from the recorder into a
	personal computer with the optional JLIP VIDEO CAPTURE
	BOX.
	For further details consult your nearest JVC dealer.

2

1 2 3

4 5 6

7 8 9

04

3 OK

1 MENU

PUSH JOG

ATTENTION

After you change your recorder's JLIP ID number, control signal transmission may not work properly. If this happens, turn off the recorder's power off once, then turn it back on and try again.

JLIP ID Number

Your recorder has its own JLIP ID number. This ID number must be unique when your recorder is connected to another device via its J terminal. The ID Number is preset to "1" at the factory. You can change this number to any number between "1" and "99". If it is necessary to change the JLIP ID number perform the following steps.

ACCESS MAIN MENU

SCREEN

1 Press MENU twice.
	ACCESS JLIP ID NO. SET
	SCREEN
	Press PUSH JOG %Þ and	MAIN MENU
	move the highlight bar	MODE SET
2 (pointer) to "JLIP ID NO.
		AUTO CH SET
	SET", then press OK.	MANUAL CH SET
		GUIDE PROG SET
		CLOCK SET
		LANGUAGE SET
		JLIP ID NO. SET
		[5°] =
		[MENU] : EXIT
	SET JLIP ID NUMBER
	Press PUSH JOG %Þ to	JLIP ID NO. SET
	enter the desired ID
3 number.
			1
		CLOCK SET
		[5°] : SELECT
		: OK
		[MENU] : EXIT
	RETURN TO NORMAL
	SCREEN
4 Press MENU or OK.