8ENINITIALSETTINGS(cont.)
Clock Set
If you performed Auto Channel Set (☞ pg. 7), the recorder’s
–a power outage of more than 3 minutes occurs.
–the tuner has been set manually.
–the user desires to set the clock slightly ahead of the actual time.
–the clock was not set even after Auto Tuner Set was performed.
Whether you perform Auto or Manual clock setting, you can use the convenient Just Clock function.
Just Clock
The Just Clock function provides accurate time keeping through automatic adjustments at regular intervals, by reading data from a PDC signal.
The Just Clock option appears in the Just Clock display, and can be set “ON” or “OFF” (the default setting is “ON”). Press OK until the Just Clock setting begins blinking, then press PUSH JOG%Þto change the setting.
Just Clock Channel Position
-
IMPORTANT: If you turn off Just Clock off, the accuracy of your recorder’s
Both Auto and Manual clock setting procedures begin from step 3.
Preparation
TURN THE RECORDER ON
1 Press OPERATE.
ACCESS CLOCK SET
DISPLAY
2 Press CLOCK on the remote control. The Clock Set display appears.
Auto Clock Set
| SET CLOCK | |
3 | AUTOMATICALLY | |
At the Clock Set display, press PUSH JOG%. The Clock | ||
Set display blinks and clock setting begins. | ||
● If the Just Clock channel position isn’t set to the | ||
| ||
| channel position on which Auto Clock data is | |
| received, “Err”(or) appears, and then the display from | |
| step 2 reappears. To set the Just Clock channel | |
| position, press OK until the Just Clock channel | |
| position begins blinking, then cycle through the | |
| numbers by pressing PUSH JOG%Þuntil the number | |
| representing the channel position in which the station | |
| transmitting clock setting data is stored appears. |
RETURN TO NORMAL
DISPLAY
4 Once clock setting is completed, press CLOCK to return to the normal display.