JVC HR-A637EH setup guide SET Date and Time, SET Just Clock, Channel Position, Manual Clock Set

Manual Clock Set

	SET DATE AND TIME
	Press PUSH JOG%Þto set the hour, then press OK. The
	“minutes” display begins blinking. Repeat the proce-
3 dure to set the minutes, day, month and year.
	Hour	Minutes
	-	-
	Day Month			Year
	-	-		-
	D		M
	After inputting the year, press OK and the Just Clock
	display appears.
4	SET JUST CLOCK
	The default setting is “ON”. Set as desired by pressing
	PUSH JOG%Þ, then press OK.

	● If you set to “OFF”, you can disregard the next step as
	you won’t be able to receive regular clock adjust-
	ments.
	SET CLOCK DATA SOURCE
5	CHANNEL POSITION
	The recorder is preset to receive clock setting and
	adjustment data from channel position 1. Press PUSH
	JOG%Þ to set the channel position to the number
	representing the station transmitting clock setting data,
	then press OK.
	START CLOCK OPERATION
6 Press CLOCK.

EN9

NOTES:

●Auto Clock and Just Clock require a PDC signal, and will not operate with a VPS signal.

●Just Clock (when set to “ON”) enables adjustment of the recorder’s built-in clock every hour on the hour, except for 11 o’clock in the evening and midnight.

●Just Clock is not effective when . . .

–the recorder’s power is on (unless the recorder is tuned to the same channel position selected in the Just Clock display).

–the recorder is in the Timer mode.

–a difference of more than 3 minutes exists between the built-in clock’s time and the actual time.

●If Just Clock is set to “ON”, the recorder’s clock is automati- cally adjusted at the start/end of Summer Time.

●Auto clock setting and Just Clock may not function properly depending on the reception condition.

●During Manual clock setting, if the day and month data are invalid (such as 31st April), the month digits are cleared automatically and the day digits begin blinking. Input the correct data.

●If, in step 3 of the Manual Clock Set procedure, the year digits are automatically cleared and the day digits begin blinking, it is possible that you have input 29th February for a non-leap year. Input the correct data.