– Recording –
Recording Features
Specifying recording length
— Instant Timer Recording (ITR)
During recording, press REC (7) on the VCR repeatedly until the recording length you want appears on the display panel. The record indicator () on the display panel starts blinking.
●Each time you press the button, recording length increases in
●The VCR shuts off after recording is finished.
●To cancel an ITR, press STOP (8) on the Remote or STOP/EJECT (0) on the VCR.
Watching one program while recording another
During recording…
●If you connect the TV and the VCR only using the RF connection to view pictures from the VCR, press TV/VCR on the Remote so that VCR mode indicator goes off from the display panel. (The TV broadcast being recorded disappears.)
●If you are using the AV connection to view pictures from the VCR, change the TV’s input mode from AV to TV.
Then, select the channel you want to watch, on the TV.
Second Audio Recording
This VCR’s
Timer Recording
Up to 8 timer recording programs can be made using Express timer programing method as far as a year in advance. Remember, the clock must be set before you can program the timer.
NOTES:
●If all the 8 programs have already been set, “PROGRAM FULL” or “Full” appears on the TV screen or the display panel.
●After timer recording is completed, the VCR turns off automatically.
●You can program the timer recording while a regular recording is in progress; the menu screens will not be recorded.
●To
●Even if a power failure occurs, the VCR keeps your timer programs. However, the clock time, channel settings, and other menu settings are lost. As a result, when the power is supplied again to this VCR after the power failure, this VCR starts the Plug&Play setting automatically to restore the clock time and channel setting. If the clock time and channel setting are restored correctly, each timer program you have made will start at its start time unless its end time has elapsed.
Express Timer Programing
Load a cassette with the record safety tab intact. The VCR turns on, and the counter is reset, automatically.
APress PROG. on the Remote to access the PlusCode No. screen.
B Press START+/– once to access |
| PROGRAM 1 |
| ||||||||
Program screen. Press |
| START | STOP |
| |||||||
| – |
|
|
| – |
| |||||
| DATE | CH |
| ||||||||
repeatedly to enter the start time, stop |
|
| |||||||||
| – |
|
|
| – – – |
| SP |
|
| ||
|
|
| |||||||||
|
|
|
|
| |||||||
time, date or channel. |
|
| |||||||||
PRESS |
| ||||||||||
● Press and hold START+/– or | 9=WEEKLY), THEN (0K) |
| |||||||||
STOP+/– to increase the time in | PRESS (PROG.) TO END |
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
30-minute intervals.
●To set the tape speed, press SP/EP.
●To