JVC HR-A630EK, HR-A631EK Turn the Recorder on, Access Clock SET Display, SET Clock, Automatically

Clock Set

1 OPERATE

	2
1	2	3

9

If you performed Auto Channel Set (☞ pg. 8), the recorder’s built-in clock is also set automatically. The Auto and Manual clock setting procedures are necessary when . . .

– a power outage of more than 3 minutes occurs.

– the tuner has been set manually.

– the user desires to set the clock slightly ahead of the actual time.

– the clock was not set even after Auto Tuner Set was performed.

Whether you perform Auto or Manual clock setting, you can use the convenient Just Clock function.

Just Clock

The Just Clock function provides accurate time keeping through automatic adjustments at regular intervals, by reading data from a PDC signal.

The Just Clock option appears in the Just Clock display, and can

q	6
	be set “ON” or “OFF” (the default setting is “ON”). Press OK
	until the Just Clock setting begins blinking, then press PUSH
	JOG%Þto change the setting.
	Just Clock Preset Position
	-

OPERATE	1	IMPORTANT: If you turn off Just Clock off, the accuracy of your
		recorder’s built-in clock may be reduced, which could

adversely effect timer recording.

Both Auto and Manual clock setting procedures begin from step 3.

	CLOCK	5	6
2,4	4
	7	8	9
		0

3

1

OK

PUSH JOG 3

Preparation

TURN THE RECORDER ON

1 Press OPERATE.

ACCESS CLOCK SET

DISPLAY

2 Press CLOCK on the remote control. The Clock Set display appears.

Auto Clock Set

	SET CLOCK
3	AUTOMATICALLY
	At the Clock Set display, press PUSH JOG%. The Clock
	Set display blinks and clock setting begins.
	● If the Just Clock preset position isn't set to the preset
	position on which Auto Clock data is received,
	"Err"(or) appears, and then the display from step 2
	reappears. To set the Just Clock preset position, press
	OK until the Just Clock preset position begins
	blinking, then cycle through the numbers by pressing
	PUSH JOG%Þ until the number representing the
	preset position in which the station transmitting clock
	setting data (BBC1, BBC2, etc.) is stored appears.

CONTINUED ON NEXT PAGE.