JVC HR-FS1U manual Express Timer Programing, PlusCode No. screen

GUIDE CHANNEL SET

GUIDE CH : 12

VCR CH : – – –

PRESS NUMBER KEY (0–9)

OR ( , ), THEN (OK)

PRESS (PROG.) TO END

– Timer Recording –

VCR Plus+® Timer Programing

The PlusCode programing numbers are the numbers next to the program in most TV listing.

Load a cassette with the record safety tab intact. The VCR turns on, and the counter is reset, automatically.

A Press PROG. on the Remote to access	PLUSCODE NO.
the PlusCode No. screen.

PRESS NUMBER KEY (0–9)

PRESS (+/–) TO SET

EXPRESS PROGRAMMING

PRESS (PROG.) TO END

BPress the appropriate Number keys to input the PlusCode number, then press OK. Check to make sure the setting is accurate on the Program screen.

PLUSCODE NO.				PROGRAM 1
			(PLUSCODE NO. 12345678)
	1 2 3 4 5 6 7 8		START	STOP
			8:00PM	10:00PM
			DATE	CH
		12/24/00		12 SP
			SUN
PRESS NUMBER KEY (0–9)		PRESS (8=DAILY, 9=WEEKLY
	THEN (OK)	STOP+/– = STOP TIME, SP/EP)
PRESS (PROG.) TO END		PRESS (OK) TO END

● If the Guide Channel Set screen appears after pressing OK, press the Number keys, CH+/– or rt to input the number of the channel on which the broadcast for the PlusCode number is received on the VCR, then press OK.

●To set the tape speed, press SP/EP.

●To change the stop time, press STOP+/–.

●To timer-record daily (Monday–Friday) or weekly serials, press DAILY (M-F) or WEEKLY. Pressing the button again makes the “DAILY” or “WEEKLY” display disappear.

●If you made a mistake, press CANCEL to access the PlusCode No. screen again.

●If an incorrect PlusCode number or the one for a broadcast already finished has been inputted, “ERROR” is displayed for about 5 seconds, then the PlusCode No. screen reappears.

CPress OK or PROG..

DPress TIMER. The VCR turns off automatically and “#” is displayed on the display panel.

Express Timer Programing

Load a cassette with the record safety tab intact. The VCR turns on, and the counter is reset, automatically.

APress PROG. on the Remote to access the PlusCode No. screen.

B Press START+/– once to access		PROGRAM 1
Program screen. Press START+/–,		START	STOP
STOP+/–,DATE+/– or CH+/–		– –:– –AM	– –:– –AM
		DATE	CH
repeatedly to enter the start time, stop
		– –/– –/– –	– – –	SP
time, date or channel.	PRESS (+/–, SP/EP, 8=DAILY
● Press and hold START+/– or	9=WEEKLY), THEN (0K)
STOP+/– to increase the time in	PRESS (PROG.) TO END

30-minute intervals.

●To set the tape speed, press SP/EP.

●To timer-record daily (Monday–Friday) or weekly serials, press DAILY (M-F) or WEEKLY. Pressing the button again makes the “DAILY” or “WEEKLY” display disappear.

CPress OK or PROG..

DPress TIMER. The VCR turns off automatically and “#” is displayed on the display panel.