![](/images/new-backgrounds/1163604/16360477x1.webp)
VCP FUNCTIONS
Make sure your TV’s input is set to the correct video channel. (Refer to page 14.)
Selecting the Menu Language for VCP
1Press [TAPE] first.
2 Press [SETUP].
•The “LANGUAGE SELECT” menu appears.
LANGUAGE SELECT
ENGLISH [ON]
FRANCAIS
ESPAÑOL
3Use [K / L] to select “ENGLISH”, “FRANCAIS” or “ESPAÑOL”, then press [SETUP] to exit.
Playback
1Press [TAPE] first.
2Insert a
To stop playback:
Press [C (stop)].
To return to the normal playback:
Press [B (play)].
3Press [OPEN/CLOSE EJECT A] to eject the cassette tape.
Note
•Tracking will be automatically adjusted during playback. To adjust the tracking manually, press
[TRACKING –/ +].
•If a cassette tape is inserted when the unit’s power is in the standby mode, the playback will not start automatically. Press [B (play)] to start playback in this case.
•Playback will stop when you change the output mode.
Index Search
An index mark will be assigned at the beginning of each recording you make. You may skip to a specific marked point by following the steps below.
1Press [TAPE] first.
2Press [SEARCH] repeatedly until “INDEX SEARCH” screen appears.
3Use [K / L] to select the index mark number you like to skip to.
INDEX SEARCH 03
4Press [B] to skip forward. Press [s] to skip backward.
The playback will start automatically from the selected index mark point.
Current program | End | ||
Beginning |
|
| |
| |||
of tape |
|
| of tape |
|
Pgrm.1
Pgrm.2
Pgrm.3
Pgrm.4
Pgrm.5
02 01 01 02 03
Index mark
Note
•This unit does not have recording function, so you must record a tape from another VHS tape recorder.
•The time gap between index marks should be greater than 1 minute for SP mode, 2 minutes for LP mode and 3 minutes for SLP mode.
EN
INTRODUCTION CONNECTIONS PLAYBACK FUNCTION SETUP VCP FUNCTIONS OTHERS
EN | 39 |