Electrical Code, ANSI/NFPA No.
L I G H T N I N G
For added protection of this video unit dur- ing a lightning storm, or when it is left unat- tended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will pre- vent damage to the video unit due to light- ning and power line surges.
P O W E R L I N E S
An outside antenna system should not be lo- cated in the vicinity of overhead power lines or other electric light or power circuits, where it can fall into such power lines or circuits. When installing an outside antenna system extreme care should be taken to keep from touching such power lines or circuits as con- tact with them might be fatal.
O V E R L O A D I N G
Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
O B J E C T S A N D L I Q U I D S
Never push objects of any kind into this video unit through openings as they may touch dan- gerous voltage points or short out parts that could result in a fire or electric shock. Never
spill liquids of any kind onto the unit. Should spillage occur, unplug unit and have it checked by a technician before use.
S E R V I C I N G
Do not attempt to service this video unit your- self as opening or removing covers may ex- pose you to a dangerous voltage or other hazards. Refer all servicing to qualified ser- vice personnel.
D A M A G E R E Q U I R I N G S E R V I C E Unplug this video unit from the wall outlet and refer servicing to qualified service per- sonnel under the following conditions:
aWhen the power supply cord or plug is damaged.
bIf any liquid has been spilled onto or ob- jects have fallen into the video unit.
cIf the video unit has been exposed to rain or water.
dIf the video unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the video unit to its normal operation.
eIf the video unit has been dropped or the cabinet has been damaged.
fWhen the video unit exhibits a distinct change in
R E P L A C E M E N T PA R T S
When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or those having the same characteristics as the origi- nal part. Unauthorized substitutions may re- sult in fire, electric shock or other hazards.
S A F E T Y C H E C K
Upon completion of any service or repairs to this video unit ask the service technician to perform safety checks to determine that the video unit is in safe operating order.
H E AT
This video unit should be situated away from heat sources such as radiators, stoves, or other products (including amplifiers) that pro- duce heat.
iv