EdgeAccess® Universal Chassis System
3.3Operation of the Rack Mount Models
When the 6002/3/4 RM module is installed into the EdgeAccess Universal Chassis System, a “STA” or status LED on the front panel will illuminate amber. This test signal from the UCS verifies that a backplane connection was established. A red light indicates a connection error.
When the 6002/3/4 LED illuminates green, the light indicates:
•The module is properly seated in the UCS slot.
•The module is receiving power from the backplane.
•The module is available to be polled by a management device.
The optional Domain Management Module (DMM) is a Management Access Module (MAM). When the DMM is installed into an active UCS, it is used for module identification and naming the installed 6002/3/4 models.
Note: Refer to the EdgeAccess UCS DMM Users Manual for additional instructions.
The optional Chassis Interconnect Module (CIM) is a connecting device that links other UCS units together. Figure 7 shows an installed DMM, CIM, a 6004 model, two 6002 modules, and other optional EdgeAccess products. The 6003 rack mount module is not shown, but is similar.
Note: Refer to the appropriate Canoga Perkins Users Manual for operating instructions.
DMM (MGR) | 6002 | 6004 DC Power Supply | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CIM | 6002 | AC Power Supply |
Figure 7. Rack Mount Module Components
6002/6003/6004 WWDM Users Manual |