Rosen Entertainment Systems R5505 owner manual Wiring the DVD player, Power Harness Connections

Page 16

Wiring the DVD player

Read the following precautions before wiring your system.

Disconnect the negative battery terminal before making any wiring connections.

Be particularly careful where you route wires. Keep them away from the engine, exhaust system, etc. Heat may damage wires.

If the fuse should blow, make sure all connections are correct and no wires are damaged before replacing the fuse. Always use fuses that are the same amperage value as the original. When replacing a fuse, never let the battery side touch any metal part or any other wire.

WARNING!

Not all Rosen and Rosen/necvox products use identically-wired four-pin power harnesses! ONLY use the four-pin power harness supplied with this unit! Use of any other four-pin harness may cause failure NOT covered by the manufacturer’s warranty!

Power Harness Connections

Wire Color Codes

Note: Connect using proper fusing with 3A fuses.

Yellow

Black

+12V Constant power

- Ground

 

Red

+12V Accessory

Wire side of Power Connector

Red

+12V Accessory

Yellow

+12V

Constant Black

Power - Ground

16R5505

Image 16
Contents Rosen Page About Installation Table of ContentsIntroduction Accessories SuppliedAbout the Registered Marks Care and Maintenance FCC ApprovalHandling Discs Liquids and the DVD playerTemperature and Moisture Discs Played by the UnitDiscs Compatible with the R5505 and R5506 DVD RegionsDiscs Incompatible with the R5505 and R5506 Using the DVD PlayerRegion Icons Front-Panel Controls V auxiliary inputsRemote Control Using the Remote ControlDVD/VCD/CD-AUDIO Playback Inserting a DVD/VCD/CDDisc Playback Stopping PlaybackPausing Playback Repeat ModeSelecting a Track or Chapter Fast Searching During PlaybackWatching Broadcast Television Using the TV Tuner in the R5505Parental Control MP3 Playback on CD-R Discs MP3 Disc Recording and File ExtensionsMP3 Playback Supported MP3 File FormatsPackage Contents Installation and Wiring Before StartingInstallation Requirements Installing the DVD player Mounting the DVD player Wiring the DVD player Power Harness ConnectionsRear Panel Connections Setup Changing SettingsChanging the Aspect Ratio Mode Changing the Video Output ModeConcealing the Angle Mark Activating Captions and SubtitlesActivating the Digital Output Selecting an Lpcm Output FrequencyChanging Language Settings Deactivating the Smart Nav On-Screen Menu DisplayTo change the soundtrack language, select Preferences Setup Options List GeneralTroubleshooting SpecificationsTinny sound or low-level sound No sound26 R5505