HSB-600(A) 2006.4.25 12:29 PM 페이지 14
Troubleshooting Guide
If a fault occurs, run through the table below before taking your unit for repair.
If the fault persists, attempt to solve it by switching the unit off and on again. If this fails to resolve the situation, consult your dealer. Under no circumstances should you attempt to repair the unit yourself. This could void the warranty.
■HDMI troubleshooting
•This unit has been designed to be compliant with HDMI(High Definition Mutimedia Interface) version 1.1. Depending on the component you have connected, unreliable signal transfers may result. In addition, some functions may be limited.
(For details, refer to the operating instructions of the connected TV, DVD player, etc.)
PROBLEM | POSSIBLE CAUSE | REMEDY |
|
|
|
No power | • The AC input cord is disconnected. | • Connect cord securely. |
| • Poor connection at AC wall outlet or the outlet is dead or off. | • Check the outlet using a lamp or another |
|
| appliance. |
|
|
|
No picture and | • The HDMI cord(or HDMI to DVI converter cord) are disconnected. | • Connect the cord correctly. |
sound | • The incorrect selection of input source on the TV. | • Select the input source correctly. |
| • The DVD player is playing a | • The HDMI OUT connector does not output the |
|
| video and audio signals of it. |
|
|
|
No picture or | • This unit is connected to TV, DVD player, etc. that does not | • This unit will not transfer the video signals. |
abnormal picture | support | This is not mulfunction. Use the TV and DVD |
|
| player, etc that do support HDCP. |
| • The settings for HDMI, COMPONENT VIDEO, etc. on the DVD | • Set them correctly depending on the connected |
| player, etc. do not match those of the connected TV. | TV. |
| • Input selection on this unit is wrong. | • Select the input corresponding to signals to be |
|
| transferred to TV. |
| • Component video connections are not made according to color | • Connect Y to Y, PB to PB(or |
| coding. | PR(or |
| • The COMPONENT VIDEO OUTs of the source equipment outputs | • Output the progressive video signals (480p or |
| the interlaced video signals (480i or 576i). | 576p). |
|
|
|
No sound or | • The HDMI OUT connector of this unit is connected to the DVI IN | • The DVI connector does not accept audio signals. |
abnormal sound | connector of TV,etc. | In such a case, you should make optical digital |
|
| connection between the components. |
|
|
|
Do not operate | • Battery dead. | • Replace with new battery. |
with remote | • Remote control unit is too far from this unit. | • Move closer. |
control unit. | • The remote sensor is obstructed. | • Remove obstacle. |
| • ⊕ and ⊖ ends of battery inserted in reverse. | • Insert battery properly. |
|
|
|
■Reference to connection
• This figure shows the best way of connections among the source equipments, this unit and the display equipment.
This unit |
14 |