Sherwood VD-4502 manual Basic Playback, Starting Playback, To remove the disc

Basic Playback

Before playing

•Turn on the TV and set the TV to the DVD Player’s input.

•Turn on the audio system and set it to the DVD Player’s input, if an audio system is connected to the DVD Player.

•DVD-Video, Video CD, CD, MP3, WMA, JPEG can be played with the DVD Player (see “Notes on Discs” on page 6 and 8). Do not play anything else.

About the marks in the pages related to disc operation

means the function or title is related to DVD-Video operation.

means the function or title is related to audio CD operation.

means the function or title is related to MP3/WMA sound operation. Both MP3 and WMA are referred to as MP3 in the following pages. means the function or title is related to JPEG image operation.

Warning

If the DVD Player is connected to the TV or amplifier through the analog audio jacks, do not play DTS-encoded discs. Excessive noise may be output from the analog stereo jacks, which may damage the connected equipment. To reproduce DTS surround sounds, digital connection to an amplifier with a DTS decoder is needed.

Starting Playback

1 Press Open/Close . ■ To stop playback

The disc tray opens. If the DVD Player is in standby mode when the Open/Close button is pressed, the DVD Player turns on and the disc tray opens. In this case, it takes several seconds until the disc tray opens.

2Place a disc on the disc tray.

Put the disc in the tray with the label side facing up. There are two different disc sizes. Place the disc in the correct guide on the disc tray.

3Press Play/Pause .

The disc tray closes and playback starts. The appropriate disc indicator lights.

The disc indicator does not light up for CDs that contain JPEG images. For the other information that appears in the display, see page 10.

If the DVD Player is in standby mode when

Play/Pause is pressed, the DVD Player turns on and playback starts. In this case, it takes several seconds until playback starts.

Tip to obtain a higher quality picture

Occasionally, some picture noise not usually visible during a normal broadcast may appear on the TV screen while playing a DVD-Video because the high resolution pictures on these discs include a lot of information. While the amount of noise depends on the TV you use, you should generally adjust the TV to reduce sharpness when viewing DVD-Videos.

Press Stop ■ .

When you press Play/Pause to restart playback, playback starts from the location where you stopped playback because the location index is stored in memory. For MP3/WMA/JPEG playback, see page 19.

Notes

•The location where playback resumes may vary depending on the disc or the scene where you stopped.

•Press Stop ■ again after stopping playback to clear the location index memory, then press Play/Pause to start playback.

■To remove the disc

Press Open/Close to open the disc tray. Remove the disc after the disc tray opens completely. After removing the disc, be sure to press the button again to close the tray.

CAUTION

Keep your fingers well clear of the disc tray as it is closing. Neglecting to do so may cause serious personal injury.

17