Loewe Centros 1172, Centros 1202 manual Timer recordings with the ShowView system

Timer recordings with the ShowView ® system

Programming timer recordings with this system is child‘s play. Most television schedule publica- tions include the SHOWVIEW code numbers along with the information about the programmes. So when you want to make a timer recording of a programme, you only need to key in the appropri- ate SHOWVIEW code number. The date, start time, end time and station are set automatically. You only need to set the recording quality and specify whether it is to be a one-off or repeated recording. You can save up to seven timer programmes on the recorder.

1.Press the green key SV/. The “Showview“ menu is displayed.

Showview

	Number				Repeat
					Once
0-9 Input		OK Enter	MENU Delete	END Close

To close the menu, press SV again . Input fields

•Number – key in the SHOWVIEW code number.

•Repeat – select the repeat type that you require (once, daily or weekly).

Checking/changing the timer recording details

You can check the programming when the DVD

recorder is switched on. Press twice. The “Timer recording list“ menu is displayed.

Timer Record List

PR	Date	Start Time	Length	Mode	VPS/	Check
					PDC
5	10/4 Di	19:20	30M	LQ	Off	Rec. OK
5	10/4 Di	20:15	45M	HQ	Off	Rec. OK

OK Edit MENU Delete REC-MENUTimer Record END Close

Edit a timer program

• Use / to select a timer recording that you wish to check.

•Press OK to go to the selected program.

•Press to open the “Timer recording“ menu, where you can make the change.

Deleting a timer program

You can deleted a timer program at any time before

•There is no electric current.

•99 titles have already been recorded on the disc.

•The recording start time is less than 3 minutes from the time it was programmed.

You cannot program the timer under the following circumstances:

•A recording is already in progress.

•The start time required is in the past.

•Seven timer recordings have already been programmed.

Multiple overlapping timer programs:

•The earlier recording takes priority.

•When the earlier recording ends, the later one will start.

•When two recordings begin at the same time, the first to be input takes priority.

If the disc is damaged, it is possible that the recording will not be done properly. Even if the “Recording OK” message appears in the “Status“ field, this is not necessarily true in this case.

2.Use the number buttons to input the SHOWVIEW code number.

•/ (left/right) – select the input fields.

•If you make a wrong input, press repeatedly

before you press OK to delete the numbers one by one and then correct the password. You can also use / to go straight to the input field that you wish to correct and then overwrite the numbers that are there by using 0-9.

3. Use	/	to place the cursor in the “Repeat“
column. Use		/	to select the “Repeat“ op-

tion (once, daily [Monday - Friday] or weekly).

4.When you have input all the programme‘s details, press OK.

The “Timer recording“ menu will appear. The settings can be altered from here.

5.Carry out steps 3-5 on the previous page (Timer recording).

recording starts.

Use / to select the entry in the timer record-

ing list that you want to delete. If you wish to

delete the recording, press .

Cancelling a timer recording

After a timer recording has begun, you can cancel

it at any time by pressing .

Conditions that will prevent recording

When the timer has been programmed, the recorder will not record under the following circum- stances:

•No disc has been inserted.

•A non-writable disc has been inserted.

•“Disc protection“ is switched on in the main menu (see page 27).

45 -

32122 DVD Rec_Centros_GB.indb 45 26.04.2005 11:23:46