LG Electronics DR1F9H owner manual Lock Parental Control Settings, Rating, Set Password, Area Code

Lock (Parental Control) Settings

Rating

Blocks playback of rated DVDs based on their content. Not all discs are rated.

1.Select [Rating] option then press B.

2.To access the Rating, Password and Area Code features, you must input the 4-digit security code you created.

If you have not yet entered a security code you are prompted to do so. Input a 4-digit code. Enter it again to verify. If you make a mistake while entering number, press CLEAR repeatedly to delete numbers one by one then correct it.

3.Select a rating using the v / V buttons.

[1]- [8]: Rating one (1) has the most restrictions and rating eight (8) is the least restrictive.

[No Limit]: If you select [No Limit], parental control is not active and the disc plays in full.

4. Press ENTER to confirm your rating selection.

Note:

If you set a rating for the recorder, all disc scenes with the same rating or lower are played. Higher rated scenes are not played unless an alternate scene is available on the disc. The alternative must have the same rating or a lower one. If no suitable alternative is found, playback stops. You must enter the 4-digit password or change the rating level in order to play the disc.

Set Password

1.Select [Set Password] option then press B.

2.Follow step 2 as shown “Rating” on left.

To change the password, select the [Change], press ENTER and input the new 4-digit code. Input it again to verify.

To delete the password, select [Delete] then press

ENTER.

If you forget your 4-digit code

If you forget your password, to clear the current password, follow the procedure below.

1.Display Setup menu then select an 1 level icon.

2.Use the Number buttons to enter the 6-digit number “210499”.

3.Select [Yes] then press ENTER. The 4-digit password is cleared. Enter a new code.

Area Code

Enter the code of an area whose standards were used to rate the DVD video disc, referring to the list (See “Area Codes”, page 47.).

1.Select [Area Code] option then press B.

2.Follow step 2 as shown “Rating” on left.

3.Select the first character using the v / V buttons.

4.Shift the cursor using B buttons and select the second character using v / V buttons.

5.Press ENTER to confirm your area code selection.

Hookup and Settings

21