Seagate ST12450W/WD manual Terminator power, J01

Page 24

22

ST12450W/WD Installation Guide, Rev. B

Terminator power

ST12450W drives may be configured in four different ways (see Figure 5); however, you usually will not need to change this option and should normally leave the drive configured as it was shipped from the factory. ST12450WD drives should be configured with a jumper connecting J01 pins 1 and 3 (and no jumper on J01 pins 2 and 4) as illustrated in Figure 5.

Power Connector

J4 J01

Pin 3

J01

Pin 1

Pin 1 Pin 2

* Term. power from drive.

* Term. power from SCSI bus. Term. power to SCSI bus.

* Term. power to SCSI bus and drive.

* Valid for single-ended drives only.

Figure 5. Setting terminator power jumpers

Image 24
Contents Barracuda 2, 2HP Contents Preface Electrostatic discharge protectionImportant safety information and precautions Page ST12450W/WD Installation Guide, Rev. B Wichtige Sicherheitshinweise ST12450W/WD Installation Guide, Rev. B Page ST12450W/WD Installation Guide, Rev. B Page SeaFAX USA 408 438-2620 England CompuServe ForumSeaFONE 408 SeaTDD 408 SeaBOARDLocation Modem number General description Barracuda 2, 2HP disc drive Characteristics ST12450W/WD Amps ST12450W/WD Installation Guide, Rev. B Initial setup information Setting the Scsi ID jumpers Setting the Scsi ID Terminating the drive Scsi bus terminationTerminating ST12450W drives Terminator power J01Changing other applicable jumper options Additional jumper optionsJ4 Pin Synchronizing spindles Multiple drive configurations Spindle sync jumpers and connectorsSpindle sync diagram Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 9. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der Kabel ST12450W/WD Installation Guide, Rev. B DC power connector Abbildung 10. Gleichstromanschluß Hinweis Page Formatting the drive