User’s Manual
MOTION SET |
| |
MOTION RECORD TIME: | 10 | |
MOTION ALARM TIME: | OFF | |
MOTION SET |
|
|
PRESS (UP, DOWN), | ENTER (SELECT) | |
PRESS (MENU) TO | EXIT |
|
|
|
|
MOTION SET:
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4 CHANNEL 2 SENSITIVITY 4 CHANNEL 3 SENSITIVITY 4 CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), | ENTER (SELECT) |
PRESS (MENU) TO | EXIT |
AREA SET:
SENSITIVITY:
Use [
Up] and [ Down] button to select the channel you want to modify, press [
SEL] to adjust sensitivity of motion detection on each channel.
High | 9, OFF) Low |
When it’s “OFF”, the channel cannot be triggered by motion.
Use [
Up] and [ Down] button to select the channel you want to modify, press [
SEL] button to enter the sensitive area of each camera. The picture of the selected channel is divided into 144(12*12) blocks, press [REW] to move left, press [FWD] to move right, press[
Up] and [ Down] to move the cursor up and down, press [
SEL] to set the block active or not.
When the block is transparent, it’s active to record. When the block is covered by shadow, it is not active, and motion in this area will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.
5.15 Video Mode
Select NTSC or PAL video system.
- 11 -