9.Connecting and configuring DIO ports
<Note> Wire Handling
Trimming Wire
When connecting a wire to a terminal block, follow the instructions below. Note the different types of wire that can be used.
Standard Wire : Peel off the wiring, cover 8~10mm and solder it. Wire gage should be AWG 22~26.
Solid Wire : Peel off the wiring cover 8~10mm and solder it. Wire gage should be AWG 20~26
Inserting & removing wire
To insert & remove wirte in TERMINAL BLOCK, use a screwdriver in the diagram to the right.
9.1.Connecting and configuring sensor
9.1.1. Specification
In order to run sensor input of eDVR MD3200 Series normally, the following conditions are required.
| Input Ch. | 16Ch Photo coupler inputs | |
|
|
| |
Spec. | Input type | N.C (Normal Close)/ N.O. (Normal Open) type. | |
|
| ||
Supported sensor | Dry contact sensor | ||
| |||
|
|
| |
| Connecting | Connecting the trimmed wire to terminal block | |
|
|
| |
Performance | Available input pulse range | Min. 500ms | |
|
| ||
Output current | Typical DC 12mA | ||
| |||
|
|
|
25