Simulation Disc to Disc

DISC ERASE

DISC ERASE? (REWRITABLE)

SIMULATION?? (DISC to DISC)

DVD Premium Pro LightScribe Series

MICROBOARDS TECHNOLOGY, LLC

9.Press YES and the Reader drive will eject and you can insert another master to register to the HDD.

10.Press NO and to exit this menu without registering data to the hard drive partition.

Important: Simulation is not allowed when using DVD+R/RW media.

1. At the COPY START? (DISC to DISC) menu, press the NO or ▼ button until the display shows SIMULATION? (DISC to DISC).

2.Place the Master Disc into the Reader drive.

3.Place the blank disc(s) into the Recorder drive(s) and wait 10 seconds for the light(s) on the front of the Recorder(s) to stop blinking.

4.Press YES.

5.The drive trays will open on any recorder without blank discs installed. If you do not want to make a copy in those drives, close the tray(s), wait for the drive light to go out, and then press the YES button to start the copy job.

6.	The display will now show the progress of the	SIMULATION	4.0GB
	Simulation Copy Job.	SIMULATION	4.0GB
		DVD		25%
		DVD		25%
7.	The Recorder(s) will eject the DVD-R discs when the
	job is complete.
Note: DVD-R media will NOT be recorded to in Simulation Mode.

Erasing RW media

1. At the COPY START? (DISC to DISC) menu, press the NO or ▼ button until the display shows DISC ERASE? (REWRITABLE):

2.Load the Recorder(s) with the CD-RW or DVD-+RW media you wish to erase. You can erase one disc at a time or fill all the Recorders to erase multiple discs at once. All discs loaded must be of the same type.

3.Press the YES button

4.The next screen asks if you want to perform a Quick Erase.

QUICK ERASE?

If you wish to perform a Full Erase, press the NO button.

FULL ERASE?

Pressing the YES button at either of these selections will show the following screen:

SURE?

5.Press the YES button if you are sure you want to erase the DVD-+RW disc. If you do not wish to erase the disc, press the NO button and you will go back to the DISC ERASE screen (step 1).

6.The screen will now show:

7. Once the erasing is complete, the Recorder(s) will eject the disc(s).