Filename |
|
XV48EX_EN_01.book Page 21 Saturday, October 9, 2004 10:34 PM |
EN 21
Basic Recording | D | Set the tape speed. |
●Turn on the TV and select the video channel (or AV mode).
●Slide the TV/VCR/DVD switch on the remote control to the right.
Press p. The current setting appears on the front display panel or TV screen. Press p again to change the setting while the tape speed is displayed on the TV screen.
E Start recording.
Slide to the right.
Press and hold 7 and press 4 on the remote control, or press 7 on the unit.
●If “O.S.D.” is set to “ON” ( pg. 53), “MARK” blinks on the screen while an index code is being marked.
●When “DIRECT REC” is set to “ON” ( pg. 53), if you press any button just after pressing 7 on the unit (or 7 and 4 on the remote control), the unit may not function properly.
B.E.S.T. works at the beginning of both the first SP and the first LP recording after inserting the cassette. ( pg. 23)
If “DIRECT REC” is set to “ON,” the programme that appears on the TV screen will be recorded. ( pg. 53)
F Pause/Resume recording.
Press 9. Press 4 to resume recording.
●You can select channel during the Record Pause mode.
G Stop recording.
Press 8. Then press x on the VHS deck to remove the cassette.
Recording Resume Function
If there is a power outage during recording, Instant Timer Recording, or timer recording ( pg. 21, 22, 26), the recording will resume automatically when power is restored to the unit unless the unit’s memory backup has expired.
A Load a cassette.
Insert a cassette with the record safety tab intact.
●The unit’s power comes on automatically and the counter is reset to 0:00:00.
B Select the VHS deck.
Accidental erasure prevention
To prevent accidental recording on a recorded cassette, remove its safety tab. To record on it later, cover the hole with adhesive tape.
NOTE:
Record safety tab
On the unit
Press VCR/DVD repeatedly so that the VCR indicator lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
When the end of the tape is reached during recording, the unit stops and “” and “$” blink on the front display panel.
C Choose a programme.
Press PR +/– or the number keys to select the channel you wish to record.
Page 21
October 9, 2004 10:34 pm