Filename [XV48EX_EN_10Subsidiary.fm] |
|
XV48EX_EN_01.book Page 62 Saturday, October 9, 2004 10:34 PM | Masterpage:Left+ |
62 EN |
| SUBSIDIARY SETTINGS (cont.) | |
Setting Station Names by ID Code | B |
|
|
Enter the new character. | |||
Set station names by ID codes (“ID”) that are registered in your | Press rt to cycle through the characters | ||
unit. | |||
| f, +, I (space) ) and stop when the desired character is | ||
Perform steps A and B of “Manual Channel Set” on page 60 | indicated, then press e to enter. Enter the remaining | ||
to access the Confirmation screen before continuing. | characters the same way (maximum of 4). After entering | ||
| all characters, press ENTER. | ||
|
A Select the item.
Press rt w e until the item you want begins blinking.
●The Confirmation screen appears.
●If you make a mistake, press w until the incorrect character begins blinking. Then enter the correct character by pressing rt.
B Access the Manual Channel Set screen.
Press ENTER twice.
C Select the new station.
Press e until the station name (ID) begins blinking, then press rt until the new station’s name (ID) you want to store begins blinking. Registered station names ( pg. 63) appear as you press rt.
D Switch the stations.
Press ENTER.
●The Confirmation screen appears.
●Repeat steps A – D if necessary.
E Close the Confirmation screen.
Press SET UP.
Setting Station Names Manually
You can set station names manually.
Perform steps A and B of “Manual Channel Set” on page 60 to access the Confirmation screen and then perform steps A and B of “Setting Station Names by ID Code” above before continuing.
A Select the character for station name.
Press e until the first letter of the station name begins blinking.
C Close the Confirmation screen.
Press SET UP.
NOTE:
The characters available for the station name (ID) are
Fine-Tuning a Stored Channel
Perform steps A and B of “Manual Channel Set” on page 60 to access the Confirmation screen before continuing.
A Select the channel to
Press rt w e until the channel you want to tune begins blinking.
B Access the Manual Channel Set screen.
Press ENTER twice. The Manual Channel Set screen appears.
C Perform tuning.
Press e until
●The Confirmation screen appears.
●Repeat steps A – C if necessary.
D Close the Confirmation screen.
Press SET UP.
Page 62
October 9, 2004 10:34 pm