GoVideo VR2940 manual Initial Setup, Detect Automatically if you are not sure

2 - Connections/Setup (cont.)

Initial Setup

After successfully connecting your DVD Recorder+VCR to your TV and other devices, you are ready to complete the Initial Setup.

1The Welcome screen is displayed. Press ENTER to continue.

2Use / to select the desired language for the Initial Setup, then press ENTER.

3Use / to select your preferred language for DVD Disc Menus, then press ENTER.

4Use / to select your preferred language for DVD audio soundtracks, then press

ENTER.

•Choose “Default” to always select the disc’s default audio language.

5Use / to select your preferred language for DVD subtitles, then press ENTER.

•Choose “Default” to always select the disc’s default subtitle language.

•Choose “Off” to always turn off subtitles.

6Use / to select the type of signal you are using to watch TV, then press ENTER.

•CATV - if using a Cable TV hookup

•Antenna - if using an Antenna

•Detect Automatically - if you are not sure

7Wait for the DVD Recorder+VCR to search for available TV stations.

•This may take a few minutes to complete.

8Set the clock.

Installation

Welcome.

Press [Enter] to begin auto channel search.

Ensure antenna is connected.

Instructions

Setup-Exit

Follow the Installation screens to set up

your DVD Recorder+VCR

•Use / to highlight each setting (hour, minute, etc.).

•Use / to adjust each setting.

•When finished, press ENTER.

9An information screen appears introduc- ing the YesDVD feature. Press ENTER to continue.

10Initial Setup is complete!

•The DVD Recorder+VCR tunes to the lowest channel found.

17