FUNAI PY90VG Installing batteries in the remote control, Using a remote control, 10 EN

Before you start

Functional overview (cont’d)

Installing batteries in the remote control

Install two “AA” size batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1 2 3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•	Do not mix new and old batteries together.
•	Do not use different kinds of batteries together,
	although they may look similar, different batteries
	may have different voltages.
•	Make sure that the plus and minus ends of
	each battery match the indications in the battery
	compartment.
•	Remove batteries from equipment that is not going
	to be used for a month or more.
•	When disposing of used batteries, please comply
	with governmental regulations or environmental
	public instruction’s rules that apply in your country

Using a remote control

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Line of sight: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23 feet (7m)

30°

or area.

• Do not recharge, short-circuit, heat, burn or

disassemble batteries.

Remote control

30°

The VCR/DVD recorder switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [SOURCE].

VCR MODE

Press [VCR ] on the remote control. (Verify that the VCR indicator is lit.)

DVD MODE

Press [DVD ] on the remote control. (Verify that the DVD indicator is lit.)

Note:

•Pressing only [SOURCE] on the front panel DOES NOT switch the mode of the remote control. You MUST select the correct mode on the remote control.

•You cannot switch to another mode (DVD or VCR) during in the timer-standby mode.

•Pressing [DVD REC] or [VCR REC] on the remote control switches immediately its respective mode so that you can start recording directly on the appropriate media.

VCR

DVD button

SOURCE

VCR button

DVD

DVD indicator

SOURCE button

VCR indicator

STANDBY-ON	TIMER SET	TIMER	OPEN/CLOSE
.@/:	ABC	DEF
1	2	3
GHI	JKL	MNO	CH
4	5	6
PQRS	TUV	WXYZ	VIDEO/TV
7	8	9
DISPLAY	SPACE	CLEAR	SETUP
	0
TITLE	DISC MENU	RETURN	OK
REC	VCR	DVD	REC
REC MODE		PLAY
RAPID PLAY	PREV	PAUSE	NEXT
SLOW	CM SKIP	STOP	SEARCH
DUBBING	ZOOM	AUDIO

10 EN

E9A12UD_PY90VG_p01-40.indd 10 2006/04/27 17:23:32