Daewoo DF-4150P, DF-4100P, DF-8100P Connectionsti, Connect to a TV with an RF coaxial input

Page 9

Identification of Controls

Rear panel

!

@#

$

^

( *

%

&

Connectionsti

• There are a variety of ways to connect the DVD Recorder+VCR to your TV and other equipment. Use only one of

INTRODUCTION

 

the connections described below. Whichever TV connection you use will work with all input sources.

 

• Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best

 

connections.

 

• For better sound reproduction, connect the DVD Recorder+VCR’s AUDIO OUT jacks to the audio in jacks of your

 

amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 17.

 

Caution

CONNECTIONS

• Make sure the DVD Recorder+VCR is connected directly to the TV, and the TV is set to the correct video input.

 

• Do not connect the DVD Recorder+VCR’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

• Do not connect the DVD Recorder+VCR via your VCR. The DVD image could be distorted by the copy protection system.

Connecting Antenna/Cable

! AC Power Cord

% Scart socket 1

Plug into a power outlet.

Connection of a TV set. Composite-output and

@ AUDIO OUT (L, R)

RGB-output

Connect to a TV or other equipment with audio

^ RF IN (FROM ANT.)

inputs.

Connect to your antenna or cable TV outlet.

# COMPONENT/PROGRESSIVE VIDEO OUT (Y Pb Pr)

& RF OUT (TO TV)

Connect to a TV with Component Video (Y Pb Pr) inputs.

$Scart socket 2

Connection of an additional device (satellite receiver, set-top box, video recorder, camcorder, etc.)

Connect to a TV with an RF coaxial input.

*COAXIAL (Digital Audio Out)

Connect to an amplifier with a coaxial digital audio input.

(S-VIDEO OUT

Connect to a TV with an S-Video Input.

1Disconnect the antenna/cable from the rear of your TV.

2Connect this cable to the jack marked RF IN (FROM ANT.) on the rear panel of the DVD Recorder+VCR.

Antenna Antenna

Cable TV

Wall Jack

Flat Wire (300ohm)

300/75ohm Adapter

OR

OR

(Not supplied)

 

 

Caution

•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the DVD Recorder+VCR.

Rear of DVD Recorder+VCR

If your cable wire is connected to your TV without a

converter or descrambler box, unscrew the wire from your TV and attach it to the RF IN (FROM ANT.) jack on the rear panel of the DVD Recorder+VCR.

Use the supplied RF cable to connect between the DVD Recorder+VCR’s OUT (TO TV) jack and the antenna input jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels (all cable channels).

14

 

 

 

15

 

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 97P95600D0-1V DVD Recorder + VCRAlcohol- based cleaning agents Safetyty InstructionsI t tiPrecautions For your own SafetyUnit leave all servicing to qualified service personnel Important SafeguardsAvoid direct exposure to beam All operating and use instructions should be followedTable of Contents Overviewi Number of this player, the disc cannot be playedFollowing discs can be used in your DVD Recorder+VCR Precautions To keep the surface cleanAbout Symbols After playing, store the disc in its caseIdentification of Controls Turns the DVD Recorder+VCR on and off Remote ControlDetails, Refer to One Touch Record OTR on Copies from DVD to VCR or from VCR to DVDConnectionsti If your cable wire is connected to your TV without aConnect to a TV with an RF coaxial input Connect to a TV with an S-Video InputConnecting a TV Connecting an Amplifier/ReceiverAmplifier. Use an optional digital coaxial audio cable Connecting Optional Equipment Initial InstallationInitial Installation DV Digital CamcorderPress Setup to exit the Setup menu Initial SetupCable If you are using basic cable to receive channels After finishing Auto Channel Search, set the clockSet Clock Auto SetSet Clock Press SETUP. The Setup menu appears Follow the same procedure as the ‘DVD Record Quality’Use œ and √ to select ‘Language‘ Press Enter to move to the second levelPress ENTER. The ‘Video‘ submenu is displayed Press Setup Use œ/√ to select ‘Preferences‘Flickering Scart jacks, set Video Output to ‘RGB’Enter your new password No signal will be output from the Digital Audio Out jacksDisplayed Use …/† to select the desired digital output typeAuto Settings PasswordPress Enter to display the submenu Press ENTER. The ‘Parental Controls‘ submenu appearsOn-Screen Displayi l Overviewverview Use …† to change the numbers Press Enter to confirm OSD Menu Options for DVDFunction does not work DVD Playback Playing a DVDSlow reverse playback is not supported VCR Playbackl Œ3 1 √ †It will be automatically selected by the DVD Recorder+VCR Othert Disci Playbackl Special Playback FeaturesTo return to normal playback, press Play DVD Recorder+VCR can display Jpeg files on CD-R/RWFollow the instructions below to record a TV program Basicic RecordingiMake sure your TV input is set to view the DVD Recorder+VCR Playing MP3 Files During a Slide ShowSP Standard Play LP Long Play, 2 times SP Tape ends Insert the VHS videotape you wish to copy into the VCR deckDuring one touch copy you can search and resume copy One Touch Copy VHS to DVDCanceling a Timer Recording When the earlier program finishes, the later program startsStopping a Timer Recording in Progress Timer Recording TroubleshootingRecording from an External Input DV appears on the front panel display and the TV screenRecording from External Components Editing You can erase titles on DVD+RW discs only Title MenuChange Disc Name Play a TitleCLR Clear the whole title Character or function and press EnterSP Add a space Save Save the title nameClean the video heads TroubleshootingTurn on the TV Audio cables are not connected securelyTechnicali l Specificationsi i ions Video output DVD Video output terminal, 1.0 Vp-p, unbalancedAudio output DVD Video output YYour 1ST Year MANUFACTURER’S Guarantee Daewoo Guarantee Department
Top Page Image Contents