Installation
-To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
-Typically a frozen still picture from a VCR. if the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.
VCR | @ | Connect | the | RF antenna out socket | of the VCR to | |
" e |
| the Antenna | s0cket | on the set |
| |
_" @ | @ | Connect | the | antenna | cable t0the | RF antenn a in |
.......... @ _ @ |
| socket of | the VCR |
|
|
VCR
tit
AUD0 OUTPUT
.£_,[_ /R/AUDioILl WDEO
,.e ® ®
O Set VCR output switch to 3 or 4 and then tune TV
@Insert a video tape into the VCR and press PLAY on the VCR. (Refer t0 the vcR owner's manual,)
Connect the AUDIO/VIDEO jacks between TV and VCR. Match the jack colors (Video = yellow. Audio Left = white and Audio Right = red/
Insert a video tape into the VCR and press PLAY on the VCR CRefer to the VCR owner's manual.I
Select AV1 input source using the INPUT button on the remote control.
- f connected to AV IN2. select AV2 input source.
•If you have a mono VCR. connect me audio cable from the VCR to the AUDIO L/MONO jack of the set
19