
Reference
Troubleshooting Check!st
The remote control doesn't work
Power is suddenly turned off
The operation does not work normally,
,,Check to see if there is any object between the product and the remote control causing obstruction.
,,Are batteries installed with correct polarity (+ to +, - to
,Correct remote operating mode set: TV, VCR etc.?
,Install new batteries.
,,Is the sleep timer set?
,,Check the power control settings. Power interrupted
,,No broadcast on station tuned with Auto off activated.
J
f
No picture &
No sound
Picture appears slowly after switching on
No or poor color or poor picture
Horizontal/verti-
cal bars or pic- ture shaking
Poor reception on some channels
Lines or streaks
in pictures
The video function does not work.
,,Check whether the product is turned on.
,,Try another channel. The problem may be with the broadcast.
,,Is the power cord inserted into wall power outlet?
,,Check your antenna direction and/or location.
,,Test the wall power outlet, plug another product's power cord into the outlet where the product's power cord was plugged in.
,,This is normal, the image is muted during the product startup process. Please contact your service center, if the picture has not appeared after five minutes.
,,Adjust Color in menu option.
,,Keep a sufficient distance between the product and the VCR.
,,Try another channel. The problem may be with the broadcast.
,,Are the video cables installed properly?
,,Activate any function to restore the brightness of the picture.
,,Check for local interference such as an electrical appliance or power tool.
,,Station or cable product experiencing problems, tune to another station.
,,Station signal is weak, reorient antenna to receive weaker station.
,,Check for sources of possible interference.
,,Check antenna (Change the direction of the antenna).
64