LG Electronics 55LS460E manual Mounting on a table

Page 17

 

 

ASSEMBLING AND PREPARING 17

Mounting on a table

 

 

 

Adjusting the angle of the TV to suit view

 

1 Lift and tilt the TV into its upright position on a

(For 32/37/42LT560C, 32/37/42/47LT560E)

table.

Swivel 90±4 degrees to the left or right and adjust

- Leave a 10 cm (4 inch) (minimum) space from

the angle of the TV to suit your view.

the wall for proper ventilation.

 

 

 

 

 

10 cm

 

10 cm

10

cm

 

 

 

 

10 cm

2Connect the power cord to a wall outlet.

Caution

yyDo not place the TV near or on sources of heat, as this may result in fire or other damage.

90˚90˚

(For 55LS460E)

Swivel 20±2 degrees to the left or right and adjust the angle of the TV to suit your view.

20˚20˚

ENGLISH

Securing the TV to a table

(For 32/37/42LT560C, 32/37/42/47LT560E)

Fix the TV to a table to prevent from tilting forward, damage, and potential injury.

To secure the TV to a table, insert and tighten the supplied screw on the rear of the stand.

CAUTION

y yWhen adjusting the angle of the TV, watch out for your fingers.

-Personal injury may occur if hands or fingers are pinched. If the product is tilted too much, it may fall, causing damage or injury.

warning

yyTo prevent TV from falling over, the TV should be securely attached to the floor/wall per installation instructions. Tipping, shaking, or rocking the TV may cause injury.

Image 17
Contents LED LCD TV English Important Safety InstructionsYyProtect the power cord from being walked on YyCleaning YyDISCONNECTING Device from the Main PowerYyGrounding YyANTENNAS Outdoor antenna grounding Can differ by countryYyGenerated Sound YyDot DefectPreventing Image burn or Burn-in on your TV screen For USA and CanadaOpen Source Software Notice LicensesTable of Contents Unpacking Installation ProcedureAssembling and Preparing AC/DC Adapter Protection cover Desk-mount Screw Cable holder Power Cord holderStand Screws For LT560E series AN-WF100 Optional Extras For LT560E, LS460E seriesSpacers For LT560C, LT560E series Side Connection panel Parts and buttonsInput Rear Connection panel For 32/37/42LT560C, 32/37/42/47LT560ESpeakers For LS460E series Screen Side Connection panelRear Connection PanelAttaching the stand Setting up the TVScreen from scratches Top ViewFor 55LS460E Stand Body M4 x Front Stand Base EnglishMounting on a table Attaching the TV to a desk Securing the TV to a wall optional YDisconnect the power first, and then moveDepending on model Wall Mount Inner SpacerTidying cables External Speaker Out Dash Remote ControlNumber button Back OK/ENTER ꔉExit ꕯ Color buttonsSymptom Possible Causes Possible Solutions General TroubleshootingDisplay Panel Picture For 32/37/42/47LT560E, 55LS460E47LT560E-UA SpecificationsResolution Horizontal Vertical RGBPC, Hdmi PC supported modeRS-232C Setup External Control Device SetupType of connector D-Sub 9-Pin Male RS-232CWire Configuration Serial female-female Null modem cable RS-232C configurationsWire ConfigurationsNot standard Set ID Set ID numberCommunication Parameters Command2 Set ID OKDatax Command1Command2 Set ID DataCrCommand2 Set ID NGDatax Transmission / Receiving protocolInput Select Command x b Power Command k aAspect Ratio Command k c Volume Mute Command k eRemote Control Lock Mode Command k m OSD Select Command k lTreble Command k r To adjust treble Bass Command k s To adjust bassAuto Configuration Command j u Channel Add/Del Command m b Energy Saving Command j qKey Command m c Channel Tuning Command m aStep Table List Channel TuningMain/Sub Two/One Using Child Safety LG Customer Information Center